Lavor XTR 1007 Yüksek Basınçlı Yıkama Makinesi
STABILITY WARNING: The machine must be always kept on horizontal bases, in a safe and stable way. USAGE DESCRIPTION OF THE MACHINE See pag.3-4-5. ASSEMBLY INSTRUCTIONS See pag.2. INTO SERVICE see * Check that the master switch is turned to "OFF" and that the water filter is fitted into the pump's inlet pipe. Screw the snap connection into place by hand, without the aid of tools. * Connect the water supply hose to the snap connection. The hose must have an inside diameter of at least 13 mm (1/2"). * Connect the high pressure hose to the pump's outlet pipe. Press the high pressure hose coupling fully down and then screw into place by hand without the aid of tools. * Connect the high pressure hose to the gun. * Turn the water tap fully on. The water temperature absolutely must be below 400C. c.•lMPORTANT: The washer machine has to operate with clean water in order to avoid any damages to the washer machine itself. * Release the gun safety catch and keep the trigger pressed, allowing the water to flow until all the air has been expelled. * Fit the lance into the gun. * Connect the plug to the power socket. * To start the machine, press the gun trigger and at the same time turn the master switch to FILLING up Fill up the tank with the fuel indicated on the technical data plate. Avoid that the tank is empty when the ma- chine is running in order not to damage the fuel pump. AWARNING: Incorrect fuel shall not used as they as provide hazard. Fill up the detergent tank with the suggested pro- ducts, suitable for the kind of washing to be carried out . AWARNING: make use only of liquid detergent, do not absolutely use acid or too 14 much alkaline products. We suggest you to make use of our products, which have been studied for the use with washer machi- nes. STARTING UP See figß Start the machine: turn the switch pos. 2 (l) ON € To wash with hot water: turn the switch pos. 1 (l) ON The burner operates when the machine is in pres- sion. HIGH PRESSURE LANCE see figm DETERGENT SUCTION See fig.ß HIGH PRESSURE HOSE see fign WATER SUPPLY Water supply collection Water supply from the water main Connecta supply hose (not included) to the water inlet of the unit and to the water supply. Open the water supply. WARNING: (symbol) machine not suitable for connection to the potable water mains. The cleaner can only be connected to the wa- ter mains if the water mains is separated by a backflow preventer. Make sure that the hose is at least Ø 13mm-1/2 inch and that it is rein- forced. A WARNING: Water that has flown through backflow preventers is considered to be nonpotable. LFIMPORTANT: Only clean or filtered water should be used for intake. The delivery of the water intake tap should be equal to the double of the maximum pump range. - Minimum delivery rate: 15 1/ min. - Maximum intake water temperature: 400C - Max inlet water pressure: 1Mpa Place the cleaner as close to the water supply system as possible. Water supply from an open container