Arçelik 9460 FCS Bulaşık Makinası
Troubleshooting Cutlery are made of low quality stainless steel. Corrosion on such items is inevitable; they should not be washed in dishwashers. Kitchen utensils that are already corroded are washed in dishwasher. Rust on a corroded item can migrate to other stainless steel surfaces and cause corrosion on those surfaces as well. Such items should not be washed in dishwashers. etergen remains in detergent dispenser. Detergent dispenser was damp when adding detergent. Make sure that the detergent dispenser is dried well prior to filling it with detergent. Detergent is added long before the washing process. Pay attention to add detergent shortly before start-up of the washing. Opening of the detergent dispenser lid is prevented during washing. Place the dishes in a way that will not prevent the detergent dispenser lid from opening and the water going into the machine from impellers. Detergent is stored under unsuitable conditions. If you are using powder detergent, do not store the detergent package in humid places. Keep it in a closed container if possible. For ease-of-storing, we recommend you to use tablet detergents. Impeller holes are clogged. Lower and upper impeller holes might be clogged with food remnants such as lemon pips. Clean the impellers regularly as illustrated in section "Cleaning and Care". ecoration$ prnamentSon • chepytensiJ99re beingerase ecorae g asses an ecorae us re porce alns are no sul a e for washing in the dishwasher. Manufacturers of some glassware and porcelain tableware items do not recommend washing such kitchen 'ishes gregratche • Kitchen utensils that contains or are made of aluminum should not be washed in dishwasher. Salt leakage exists. Pay attention not to spill salt around the salt Illing hole while adding salt. Spilled salt can cause scratches. Make sure that the salt reservoir lid is tightly closed after finishing the filling process. Run the prewash programme to remove the salt that spilled inside the machine. Since the salt granules that will remain under the lid will dissolve during prewash, causing the lid loosen, check the lid once again at the end of the programme. Water hardness setting is low or salt level is insufficient Measure the hardness of the supply water appropriately and check the water hardness setting. 50/51 EN Dishwasher / User's Manual