Arçelik 9460 FCS Bulaşık Makinası
Installation extension cables or multi-plugs. i Drainpipe must be connected to the sewage system and it should not be connected to any surface water. Adjusting the feet If the door of the product cannot be closed properly or if the product swings when you push it slightly, then you need to adjust the feet of the product. Adjust the feet of the product as illustrated in the installation manual supplied with the product. Electrical connection Connect the product to a grounded outlet protected by a fuse complying with the values in the "Technical specifications" table. Our company shall not be liable for any damages that will arise when the product is used without grounding in accordance with the local regulations. Connection must comply with national regulations. Power cable plug must be within easy reach after installation. Unplug the product after the washing programme is over. The voltage and allowed fuse or breaker protection are specified in the "Technical specifications" section. If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified electrician install a 16 Amp fuse. The specified voltage must be equal to your mains voltage. Do not make connections via Dishwasher / User's Manual f f Damaged power cables must be replaced by the Authorised Service Agent. If your dishwasher is equipped with internal illumination, lamp should only be replaced by the Authorised Service Agent in case of failures that may occur on the lam If the product has a failure, it should not be operated unless it is repaired by the Authorised Service Agent! There is the risk of electric shock! Initial use Before starting to use the product, make sure that all preparations are made in accordance with the instructions in sections "Important safety instructions" and "Installation". To prepare the product to do the dishes, perform first operation in the shortest programme with detergent while the machine is empty. During the initial use, fill the salt reservoir with I litre of water prior to filling it with salt. There might be a small amount of water left in the product after factory quality control tests. This has no harm on the product. 11/51 EN