Fakir LINO Otomatik Ekmek Yapma Makinası

Questions & Answers on Bread Baking Machines

              PROBLEM                          CAUSE                           SOLUTION

 Smoke comes out of the         The ingredients stick to the      Pull out the plug and clean the outside 
 baking compartment or of the   baking compartment or on the      of the baking tin or the baking 
 vents                          outside   of the   baking   tin   compartment.

 The bread goes down in the     The bread is left too long in the Take the bread out of the baking tin 
 middle and is moist on the     tin after baking and warming.     before the warming function is over.
 bottom.
 It is difficult to take the    The bottom of the loaf is stuck   Clean the kneading hooks and shaft 
 bread out of the baking tin.   to the kneading peg.              after the baking. If necessary, fill the 
                                                                  baking tin with warm water for 30 
                                                                  minutes. Then the kneading pegs can 
                                                                  be easily removed and cleaned.

 The ingredients are not mixed  Incorrect program setting.        Check the selected menu and the 
 or the bread is not baked                                        other settings.
 correctly.                     The START/STOPP key was           Do not use the ingredients and start 
                                touched while the machine was 
                                working.                          over again.

                                The lid opened several timers     The lid is to be opened only if the time 
                                while the machine was working.    left on the display is more than 1:30 
                                                                  hours (only for programmes „1, 2, 3, 
                                                                  4“). Make sure that lid was closed well 
                                                                  after being opened.

                                Long    blackout    while   the   Do not use the ingredients and start 
                                machine was working.              over again.

                                The rotation of the kneading peg  Check that the kneading peg are 
                                is blocked.                       blocked by grains, etc. Pull out the 
                                                                  baking tin and check whether the 
                                                                  drivers turn. If this is not the case, 
                                                                  send the appliance to the customer 
                                                                  service.

 The appliance does not start.  The appliance is still hot after  Press the START/STOPP button until 
 The time acoustic signal goes  the previous baking procedure.    the normal programme appears. Pull 
 off. The display shows E 01.                                     out the plug. Take out the baking tin
                                                                  and   leave    it to cool   at  room 
                                                                  temperature. Then insert the plug and 
                                                                  start again.

 “EEE” or a similar signal      Program or electronic error.      Start the test run by pulling out the 
 appears on the display.                                          plug, keeping the menu key pressed
                                                                  and   inserting   the   plug   again. 
                                                                  Release the key. The menu performs 
                                                                  a test run. Unplug again and then plug 
                                                                  in again. The normal program should 
                                                                  appear on the display. If this is not 
                                                                  the case, send the appliance to the 
                                                                  Customer Service.



                                                                                                23