Electrolux ESI5510LAX Bulaşık Makinesi
ENGLISH Possible cause and solution 19 Problem and alarm code The program does not start. The appliance does not fi I with water. The dsp ay shows 1 The appliance does not drain the water. The disp ay shows IPO. The anti-flood device is on. -The disp ay shows The appliance stops and starts more times during operation. The program lasts too long. The remaining time in the display increases and skips nearly to the end of pro- gram t me. The options of the program have to be set again every time. Small eak from the appli- ance door. The appliance door is diffi cult to close. • • • • • • • • • • • • • • • • • • • • • • • Make sure that the appliance door is closed. Press Start. If the de ay start is set, cance the setting or wait for the end of the countdown. The appliance has started the procedure to recharge the resin inside the water softener. The duration of the procedure is approximately 5 minutes. Make sure that the water tap is open. Make sure that the pressure of the water supply is not too low. For this information, contact your loca water authority. Make sure that the water tap is not c ogged. Make sure that the filter •n the inlet hose •s not clog- ged. Make sure that the inlet hose has no kinks or bends. Make sure that the sink spigot is not clogged. Make sure that the filter n the out et hose is not clog- ged. Make sure that the interior filter system is not clogged. Make sure that the drain hose has no kinks or bends. Close the water tap and contact an Authorised Service Centre. It is norma. It prov des optimal c ean ng results and energy An energy-saving option has been se ected. If the de ayed start option is set, cancel the delay set- ting or wait for the end of the countdown. This is not a detect. The app iance is working correctly. To save your favourite configuration use option MyFa- vourite. The appliance is not eve. Loosen or tghten the ad- justable feet (if applicable). The appliance door is not centred on the tub. Adjust the rear foot (if appl'cable). The appliance is not level. Loosen or tighten the ad justable feet (if applicable). Parts of the tableware are protruding from the bas- kets.