Bosch KDN74AF20Nlu Donduruculu
1. Position the appliance in the intended installation area. 2. Screw the front feet out until they stand firmly on the ground and align the appliance at the front. 3. Use a spirit level to check that the appliance is horizontal. Note The front feet must stand firmly on the ground so that the appliance does not roll away. Connecting the appliance After setting up the appliance, wait for at least one hour before starting the appliance up. The oil contained in the compressor may have been displaced into the refrigeration system during transport. Before starting the appliance up for the first time, clean its interior (see section "Cleaning the appliance"). Electrical connection The socket must be near to the appliance and easily accessible after the appliance has been installed. The appliance conforms to protection class l. Connect the appliance to a 220-240 V/50 Hz alternating current supply using a socket with protective earthing conductor which has been correctly installed. The socket must be protected by a fuse with a rating of 10 A to 16 A. en In the case of appliances operated outside of Europe, check whether the voltage and type of current specified conform to the values of your electricity grid. You will find this information on the rating plate. Figure Warning The appliance must never be connected up to an electronic energy-saving socket. Sinusoidal-commutated and line- commutated inverters can be used with our appliances. Line-commutated inverters are used with photovoltaic systems that are connected directly to the national grid. Sinusoidal- communicated inverters must be used with standalone applications (e.g. on ships or mountain huts) that do not have a direct connection to the national grid. Attaching handles Figure O Only attach the handles once the appliance has been positioned in its installation location and has been aligned so that it is level. . Push the holders into the guides. 2. Position and tighten the screws. 3. Push the handles onto the holders and slide them downwards. The "Top" sticker must be facing upwards. 4. Position and tighten the screw. 9