Indication
Unit is overheated and is disabled
momentarily to cool down.
Unit is malfunctioning. Turn the unit
off, wait a few moments and try
again. If problem persists, the unit
should be returned for repair.
Nose cone is removed or loose.
Intensity/Flash Mode LED
All currently selected
LEDs flashing
Intensity LEDs flashing
in sequence
All LEDs flashing with
warning beep
16
17
There is a strange smell.
■
Be sure the area is completely shaved before treatment.
The treated areas become red after treatment.
■
This is normal and the redness should subside. If not, try using a lower light i ntensity.
I have not seen optimal results or hair has begun to grow back.
■
Hair may begin to grow back after your initial treatment.
This is perfectly normal. For
optimal results, repeat the treatment when you notice hair regrowth.
BE AWARE
If the unit is used over an extended period of time, the unit might automatically
disable momentarily (estimated 40 seconds) to cool down. Once the unit has
cooled down, it will be ready to use again.
Status LED & Audio
3. Replace with a new bulb cartridge. Replacement model: SP-IPL
CAUTION: When replacing the bulb cartridge, do not touch the flash bulbs directly
as this leaves oils and residue. Doing so could reduce the effectiveness
of the bulbs or cause them to crack during treatment.
4. Replace the nose cone, making sure it snaps into place.
Storage
■
Switch off the unit, unplug it and let it cool down for 10 minutes before storage.
■
Store the unit in a dry place at a temperature between 15º C and 35º C.
Troubleshooting
Always read these instructions fully before using i-Light.
Refer to this troubleshooting guide if you experience any problems with i-Light, as this sec-
tion addresses the most common problems you could encounter with i-Light.
If you have followed the instructions in this section and continue to experience problems,
please contact the Remington® Service Center for further assistance.
I turn the power switch ON, but the unit is not working.
■
Make sure the unit is plugged into a working electrical outlet.
■
Try switching to a different outlet.
The unit appears to have cracks or is broken.
■
Do not use if the unit is damaged. If you have concerns about using the unit,
discontinue use and contact the Remington® Service Center for further assistance.
I have switched the unit ON, but I cannot increase or decrease the light intensity.
■
Try resetting the unit by turning it off and waiting several seconds before turning it
back on.
The Bulb Status Indicator Light turns green but the unit does not flash when the
button is pressed.
■
Make sure the Skin Contact Sensor is in full contact with the skin.
■
Try resetting the unit by turning it off and waiting several seconds before turning it
back on.
1__I_I_1
100827_REM_IFU_IPL5000_21L
1-1
GB16-GB17
.11.1
05.11.10 1:13:25
İlginizi çekebilecek Remington marka Epilasyon Cihazı ürünleri
