Kärcher K3 Yüksek Basınçlı Yıkama Makinesi
Operation A TTENTION Dry running of more than 2 minutes leads to damage of the high-pressure pump. If the appliance does not build up pressure within 2 minutes, switch the appliance off and proceed in accordance with the instructions in Chapter ' 'Troubleshooting" High pressure operation CAUTION Keep a distance of at least 30 cm when using the jet for cleaning painted surfaces to avoid damage. A TTENTION Car tyres, paint or sensitive surfaces such as wood should not be cleaned with the dirt blaster, as there is a risk Of damage. Illustration Push the spray lance into the trigger gun and fasten it by turning it through 900 Turn on the appliance "I/ON". Unlock the lever on the trigger gun. Pull on the lever Of the trigger gun; the device will switch on. Note: Release the lever of the trigger gun; the device will switch Off again. High pressure remains in the SYS- tem. Operation with washing brush A TTENTION Risk of damage to the paintwork When working with the washing brush, it must be free Of dirt or other particles. Push the washing brush into the trigger gun and fasten it by a 900 turn. Note: If required, the washing brushes can be used to work with detergent. Operation with detergent Note: Detergent can only be added when the device is operated in low pressure mode. A DANGER When using detergents, the material data safety sheet issued by the detergent manufacturer must be adhered to, especially the instructions regarding personal pro- tective equipment. Illustration Fill the detergent solution in the detergent tank (ob- serve dosage instructions on the packaging of the detergent). Illustration Close the detergent tank with the lid. Lock the detergent tank in place on the appliance. Illustration Use spray lance with pressure regulation (Vario power). Turn the spray lance to "Mix" position. Note: This will mix the detergent with the water stream. 12 Recommended cleaning meth Spray the detergent sparingly on the dry surface and allow it to react, but not to dry. Spray off loosened dirt with the high pressure jet. Optional Fill the detergent solution in the detergent tank Of the foam nozzle (observe dosage instructions on the packaging of the detergent). Connect the detergent tank to the foam nozzle. Connect the foam nozzle to the trigger gun. Interrupting operation Release the lever on the trigger gun. Lock the lever on the trigger gun. Insert the trigger gun in its holder. During longer breaks (more than 5 minutes), also turn the appliance off using the "O/OFF" switch. Finish operation CAUTION Only separate the high-pressure hose from the hand spray gun or the appliance when there is no pressure in the system. After operation with detergent: Run the machine for approximately 1 minute for a clear rinse. Release the lever on the trigger gun. Turn Off the appliance "O/OFF" Disconnect the mains plug from the socket. Turn off tap. Press the lever on the trigger gun to release any re- maining pressure in the system. Lock the lever on the trigger gun. Detach the appliance from the water supply Transport CAUTION Risk of personal injury or damage! Mind the weight of the appliance during transport. When transporting by hand Pull the appliance by its transport handle. When transporting in vehicles Empty detergent tank. Secure the appliance against shifting and tipping over.