Kärcher K 5.79 MD T250 Yüksek Basınçlı Yıkama Makinesi
Check whether the voltage indicated on the type plate corresponds to the volt- age of the mains supply. Check the mains connection cable for damages. Pressure does not build up in the appli- ance Check setting at the spray lance. Appliance ventilation: Switch the appli- ance on with the high-pressure hose detached and operate (max. 2 minutes) until the water exits the high-pressure connection without bubbles. Switch off appliance and reconnect high-pressure hose. Check the water supply. Pull out the sieve in the water connec- tion using flat-nose pliers and clean un- der running water. Appliance does not start, motor hums Cause: Voltage reduction due to weak mains supply or when using an extension cable. When switching on, first pull the lever of the trigger gun and then switch the ap- pliance switch to "I/ON". Strong pressure fluctuations Clean high-pressure nozzle: Remove dirt and debris from the nozzle bore, us- ing a needle and rinse through with wa- ter from the front. Check water flow quantity. Appliance is leaking Slight leakage from the appliance pump is normal. If the leakage increases con- tact the authorized customer service. No detergent infeed Use spray lance with pressure regula- tion (Vario Power). Turn the spray lance to "Mix" position. Check the settings at the dosage regu- lator for detergent. Clean the detergent suction hose filter. Check the detergent suction hose for kinks. 17