Kärcher K 5.79 MD T250 Yüksek Basınçlı Yıkama Makinesi
Operation Danger The trigger gun is subjected to a recoil force when the water jet is discharged. Make sure that you have a firm footing and are also holding the trigger gun and spray lance firmly. Caution Prior to cleaning, make sure that the high pressure is placed safely on level ground. Wear protective goggles and protective clothing during the cleaning process. Unlock the lever on the trigger gun. Pull on the lever of the trigger gun; the device will switch on. Note: Release the lever of the trigger gun; the device will switch off again. High pres- sure remains in the system. Spray lance with pressure regulation Carrying out the most common cleaning tasks. The work pressure can be stageless- ly regulated between "Min" and "Max". Release the lever on the trigger gun. Turn the spray lance to the desired po- sition. Note: Suitable for working with detergent; for this, turn the spray lance to the "Mix" po- sition. Spray lance with Dirtblaster For particularly dirty items or areas. Caution Car tyres, paint or sensitive surfaces such as wood should not be cleaned with the dirt blaster, as there is a risk of damage. Not suitable for use with detergents. Working with detergent Please use exclusively KÄRCHER deter- gents and care products to carry out the re- spective cleaning task, as these were specifically developed for your appliance. The use of other detergents and care prod- ucts may lead to premature wear and can invalidate your warranty claims. Please ob- tain information at your local dealer or re- quest information directly from KÄRCHER. Use spray lance with pressure regula- tion (Vario Power). Turn the spray lance to "Mix" position. Note: This will mix the detergent with the water stream. Fill the detergent solution in the deter- gent tank (observe dosage instructions on the packaging of the detergent). Adjust the suction volume of the deter- gent solution by means of the dosage regulator for detergents. Recommended cleaning method Spray the detergent sparingly on the dry surface and allow it to react, but not to dry. Spray off loosened dirt with the high- pressure jet. Interrupting operation Release the lever on the trigger gun. Lock the lever on the trigger gun. During longer breaks (more than 5 min- utes), also turn the appliance off using the "O/OFF" switch. Insert the trigger gun in its holder. Finish operation Caution Only separate the high-pressure hose from the trigger gun or the appliance while there is no pressure in the system. After working with detergent, suspend detergent suction hose in a container filled with clear water, switch the appli- ance on for around 1 minute once the spray lance has been removed and rinse until water runs clear. Release the lever on the trigger gun. Turn off the appliance "O/OFF". Turn off tap. Press the lever on the trigger gun to re- lease any remaining pressure in the system. Lock the lever on the trigger gun. Pull out the mains plug. 15