Fakir E 240 Elektrikli Süpürge

   ATTENTION: Do not vacuum without the           • Remove the filter holder with air inlet filter(1). 
   dust bag.                                        Your first flip the filter holder forwards and 
   ATTENTION: Replace the dustbag when              then pull the filter up and out.
   the vacuum cleaner is not connected to the 
   mains.







                                                  • Remove the air inlet filter(1) from the filter 
•  Remove the hose from the air-inlet.              holder(2).
•  Open the dust compartment cover (1) by         • Clean the filter holder.
   unlatching and susequently raising it up to    • ‹nsert the new new air inlet filter into the 
   the highest position until it locks byself.      filter holder.
   Note: Be careful when removing the dust        • ‹nsert the filter holder with new air inlet filter 
   filter bag so that no dust escapes!              into its bracket from nabove and push it 
                                                    down until it audibly locks into place.
                                                  • Replace the dust filter bag and close the 
                                                    dust compartment cover. The cover clicks 
                                                    audibly into place.

                                                    ATTENTION!!! This filters are not washable. 
                                                    The exhaust filter may be not re-used.

                                                    AIR-OUTLET FILTER REPLACING
•  Pull the dust filter bag (1) up and out of the • Switch off the vacuum cleaner and open 
   dust filter holder.                              the vacuum cleaner such way as in case 
•  Remove any dust that have may collected          of dust bag replacing.
   in the dust compartment.
•  Push the new dust filter bag in the filter bag 
   holder.
•  Close the dust compartment cover. ‹t clicks 
   into place audibly.

   Note: The dust compartment cover can 
   only be closed with a dust filter bag in 
   place!
                                                  • Remove the exhaust filter(1). Unlatch the 
   AIR-INLET FILTER REPLACING                       lock and slightly lift the filter.Now you can 
•  Switch off the vacuum cleaner and open           pull out the filter towards the front.
   the vacuum cleaner such way as in case         • ‹nsert a new filter push it down slightly until 
   of dust bag replacing,                           it locks into the holder.
                                                  • Replace the dust filter bag and close the 
                                                    dust compartment cover. The cover clicks 
                                                    audibly into place.

                                                    Note: Make sure that the exhaust filter is 
                                                    always properly locked into position, 
                                                    otherwise the exhaust air will be not properly 
                                                    filtered.

                                                                                       11