Sürüm TAMBURLU Çayır Biçme Makinesi

         Her biçme diskinde her biri yay baskılı üçer adet bıçak vardır.Bıçaklann her iki tarafı da kesme özelliğine 
    sahiptirDiskler birbirlerine ters döndüklerinden,bir diskte aşınan bıçakların bir yüzeyi diğer diskte kullanılabilirKesici bıçaklar 
    özel bir anahtarla disk sökülmeden basit bir şekilde yerinden çıkartılıp değiştirilebilir.

         Tamburlu Çayır Biçme makinesinin çalışma emniyeti .bu tip makinelarda kullanılan yay baskılı emniyet düzeni ile 
    sağlanmıştirAyrıca traktör kuyruk milinden mafsallı mil ile hareketin iletildiği makinanin ana milinde yay emniyet kavraması 
    mevcuttur.
    05 - MAIN INFORMATIONS FOR MACHINE
         It is connected with a three pointed hanging system to tractor and 3 t is specified as pulleyed.rotary cuttered,free 
    cuiling possi bil ity and manufactu red by SÜR ÜM Tarım Mak.San.

         There are three pointed hanging system , gear box, V belt-pulley system , two of cutter pulley, 6 of leaf cu ter , jointed 
    axle to move carrying bars connected to three pointed hanging system and carrying chassis on the pulleyed Mower.

         The machine is designed as two d ifterent chassis.Both three pointed hanging system and belt-pulley system form 
    the first chassis of the machine.The gear box is the second chassis which bear the pulleys at the same time.Teh gear box and 
    first chassis are connected to each other with two piece of slider bearing by the side of machine.The pulley activate to gear is 
    formed by bearing.Furthermore two of chassises are connected to three pointed hanging system with two of paralel steel bar 
    which has spring pressed and this causes to adjust the length of machine.

         The rotary mower is activated from upper Side of machine. The first movement is transmitted from tractor back 
    pivot axle to three grooved V belt-pulley system , then it is transmitted to gear box and pulley e:de through gears and last of all 
    movement is transmitted ta cutter disks. At the first step movement is transfered with belt-pulley system and at the second 
    step it is transfered to gear box then to cutter disks.

         Fili up the gear box with suitable oil.Oil leakage is obtained with a jointThere are double of gear which increase the 
    movement comes from pulley and two of double gear which transfer the movement to cutter disks in the gear box.There are 
    total three-double gear in the gear box.

6