TO REMOVE RESIDUE
To remove residue from the stainless steel tweezers, dampen a swab with alcohol. Gently run the swab
over the tweezers until the residue has been removed.
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR INJURY
TO PERSONS:
To prevent accidents, keep the product away from hair on your scalp, your eyebrows, eyelashes as
well as clothes, brushes, wires etc...
An appliance should never be left unattended when plugged into a power outlet.
Always unplug your unit when it is not in use, unless it is being recharged.
Keep the power plug and cord away from heated surfaces.
This product is not washable or water resistant. Do not use in the bathtub or shower.
Make sure the power plug and cord does not get wet. Do not reach for your unit if it has fallen
into water – immediately unplug it from the electrical outlet.
Do not plug or unplug the product with wet hands.
Do not store your unit where it can fall into a tub or sink of water.
Do not wrap the cord of your adaptor around the unit.
Do not use the product with a damaged cord. A replacement can be obtained via our Remington®
Service Centres.
Store the product at a temperature between 15°C and 35°C.
Only use the parts supplied with the appliance.
Keep this product out of reach of children. The use of this appliance by persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge can give cause to hazards. Persons
responsible for their safety should give explicit instructions or supervise the use of the appliance.
CLEANING THE SHAVING HEAD
Ensure the epilator is turned off and disconnected from the mains.
Press the head release button and remove the shaving head.
Remove the blade and trimmer assembly by placing your fingers either side of the assembly
and pulling upwards.
Gently shake the blade and trimmer assembly to remove the hair. Brush the trimmers
and shaver housing.
Replace the blade and trimmer assembly.
Brush the accumulated hair from the tweezers by turning the barrel manually. Alternatively, remove
the epilation head from the epilator and rinse under running water. Allow to dry completely before
attaching to the epilator body. (Diagram F)
NOTE: The body of the epilator is not washable. Do not submerge in water.
Replace the curved epilation head, ensuring that the wire is at the higher side of the epilator.
Replace the epilation head assembly into the unit by gently pressing until it clicks into place.
NOTE: Never use the cleaning brush on the foil as damage may occur.
CAUTION: Make sure that the cotton swab is not soaked in alcohol as this may damage the epilator.
Not suitable for cleaning under water.
IMPORTANT SAFETY INSTRUCTIONS
AE HR/ SL GR RO TR RU PL HUN CZ SK P FIN S DK I
E F NL D GB
SRB
5
1I.i
100550_REM_IFU_EP6020_22L.indd GB5
..1
29.07.10
:20:56
İlginizi çekebilecek Remington marka Epilasyon Cihazı ürünleri
