Kärcher K7 Premium Full Control Yüksek Basınçlı Yıkama Makinesi
Care and maintenance A DANGER Risk of electric shock. prior to al/ work on the appliance, switch Off the ap- pliance and pull the power plug. Clean the sieve in the water connection Clean the sieve in the water connection regularly. Remove coupling from the water connection. A TTENTION The sieve must not be damaged. Illustration m Pull the sieve out using flat pliers Clean the sieve under running water. Reinsert the sieve into the water connection. Changing the batteries of the trigger gun The batteries are depleted if nothing is shown on the display of the trigger gun anymore. Two batteries or accumulators of the size AAA are re- quired. Illustration Push the locking slide. Open battery compartment. Remove the batteries. Dispose of the used batteries according to the local provisions. Insert new batteries and observe the correct orien- tation of the terminals. Close battery compartment. Troubleshooting DANGER Risk of electric shock. Turn Off the appliance and re- move the mains plug prior to performing any care and maintenance work. Repair work and work on the electrical components may only be performed by an authorised customer service. You can rectify minor faults yourself with the help of the following overview. If in doubt, please consult the authorized customer ser- vice. Appliance is not running push the lever Of the trigger gun, the device will switch on. Check whether the voltage indicated on the type plate corresponds to the voltage of the mains sup- Check the mains connection cable for damages. Motor overloaded, the motor circuit breaker has tripped Turn off the appliance "O/OFF". Allow the device to cool down for one hour. Switch on the device and put it into operation again. If the malfunction occurs repeatedly, have the de- vice checked by the customer service. Appliance does not start, motor hums Voltage reduction due to weak mains supply or when using an extension cable. upon switch-on, push the lever Of the trigger gun first and then switch the power switch to "I/ON" Pressure does not build up in the applian Check setting at the spray lance. Check water supply for adequate delivery rate. pull Out the sieve in the water connection using flat- nose pliers and clean under running water. Remove air from appliance before operation. Switch on the appliance without connection the HP hose (max. 2 minutes) and run it until the water dis- charging from the HP outlet is free of bubbles. Switch off appliance and reconnect HP hose. Strong pressure fluctuations Clean high-pressure nozzle: Remove dirt and de- bris from the nozzle bore, using a needle and rinse through with water from the front. Check water flow quantity. Appliance is leaking Dropwise leakage of the device is normal for tech- nical reasons. If the leakage increases contact the authorized customer service. No detergent infeed use Vario power spray lance. Turn the spray lance to "Mix" position. Check whether the Plug •n' Clean detergent bottle is placed into the detergent connection facing down. NO pressure indicator on the trigger gun Check replace the batteries Spare parts Use only Original KARCHER spare parts. You will find a list of spare parts at the end of these operating instruc- tions. 15