Kärcher K 6.260 Yüksek Basınçlı Yıkama Makinesi
Maintenance and care Danger Turn off the appliance and remove the mains plug prior to any care and mainte- EN-8 Check the mains connection cable for damages. Pressure does not build up in the appli- ance nance work. Maintenance The appliance is maintenance-free. Cleaning Prior to longer periods of storage, e.g. in the winter: Completely drain all water from the ap- pliance: Switch the appliance on with detached high-pressure hose and de- tached water supply (max. 1 minute) and wait, until no more water exits at the high-pressure connection. Turn off the appliance. Illustration Pull out the sieve in the water connec- tion using flat-nose pliers and clean un- der running water. Spare parts Use only original KÄRCHER spare parts. You will find a list of spare parts at the end of these operating instructions. Troubleshooting You can rectify minor faults yourself with the help of the following overview. If in doubt, please consult the authorized customer service. A Danger Turn off the appliance and remove the mains plug prior to any care and mainte- nance work. Repair works may only be performed by the authorized customer service. Appliance is not running Pull on the lever of the trigger gun; the device will switch on. Check whether the voltage indicated on the type plate corresponds to the volt- age of the mains supply. Check setting at the spray lance. Appliance ventilation: Switch the appli- ance on with the high-pressure hose detached and operate (max. 2 minutes) until the water exits the high-pressure connection without bubbles. Switch off appliance and reconnect high-pressure hose. Check the water supply. Pull out the sieve in the water connec- tion using flat-nose pliers and clean un- der running water. Appliance does not start, motor hums Cause: Voltage reduction due to weak mains supply or when using an extension cable. When switching on, first pull the lever of the trigger gun and then switch the ap- pliance switch to "WON" Strong pressure fluctuations Clean high-pressure nozzle: Remove dirt and debris from the nozzle bore, us- ing a needle and rinse through with wa- ter from the front. Check water flow quantity. Appliance is leaking Slight leakage from the appliance pump is normal. If the leakage increases con- tact the authorized customer service. No detergent infeed Use spray lance with pressure regula- tion (Vario Power). Turn the spray lance to "Mix" position. Check the settings at the dosage regu- lator for detergent. Check the detergent suction hose for kinks. 23