Kärcher K 5.500 Yüksek Basınçlı Yıkama Makinesi
Fill the KÄRCHER suction hose with backflow valve with water, screw to water supply and hang into the water butt. Separate the high pressure hose from the high pressure connection of the appli- ance. Switch the appliance on (I/ON) for a max. of 2 minutes and wait until the water exits the high-pressure connection without bub- bles. Turn off the appliance "O/OFF". Start up Caution Dry runs lasting longer than two minutes lead to damages to the high pressure pump. If the appliance does not build up pressure within two minutes, switch it off and proceed as in- structed in the Chapter "Troubleshooting" Illustration Insert the high pressure hose tightly into the quick coupling on the appliance, it will lock in audibly. Note: Make sure the connection nipple is aligned correctly. Check the secure connection by pulling on the high-pressure hose. Illustration Push the spray lance into the trigger gun and fasten it by turning it through 900. Completely open the water tap. Insert the mains plug into the socket. Turn on the appliance "I/ON' Operation Danger The tngger gun is subjected to a recoil force when the water jet is discharged. Make sure that you have a firm footing and are also hold- ing the trigger gun and spray lance firmly. Caution Prior to cleaning, make sure that the high pressure is placed safely on level ground. Wear protective goggles and protective cloth- ing during the cleaning process. Unlock the lever on the trigger gun. Pull on the lever of the trigger gun; the de- vice will switch on. 16 Note: Release the lever of the trigger gun; the device will switch off again. High pressure re- mains in the system. Spray lance with pressure regulation Carrying out the most common cleaning tasks. The work pressure can be stagelessly regulated between "Min" and "Max". Release the lever on the trigger gun. Turn the spray lance to the desired posi- tion. Note: Suitable for working with detergent; for this, turn the spray lance to the "Mix" position. Spray lance with Dirtblaster For particularly dirty items or areas. Caution Car tyres, paint or sensitive surfaces such as wood should not be cleaned with the dirt blast- er, as there is a risk of damage. Not suitable for use with detergents. Washing brush Note: Suitable for use with detergents. Set the dosage regulator to the desired suction volume for detergent. Rotary washing brush The rotating washing brush is ideally suited for the cleaning of vehicles. Caution Please make sure that the washing brush is free from dirt or other particles. Otherwise, it may damage the paint work. Note: Suitable for use with detergents. Set the dosage regulator to the desired suction volume for detergent. Delta-Racer DI 50 The Delta-Racer combines a wash brush with a rotating high pressure jet. Therefore, it is es- pecially suited for vehicle cleaning or heavily soiled surfaces. Danger Do not reach under the edge of the Delta Racer during op- eration!