Fakir VIPER TURBO Elektrikli Süpürge
HOW TO USE extend the cable beyond the red mark.
Ready for use Press the ON/OFF button to switch the
Connect the suction hose, telescopic appliance on. It is advisable to set the
tube and accessories correctly. electronic power regulator to MIN before
Insert the hose spile into the air intake switching the appliance on.
duct on the top of the appliance. To do
this, slide intake duct cover insert the
tube and press until it clicks into position.
Using the cleaning accessories
Press down the side of bristle button with
mark “ L l l l ” and then use the bristle
extended for hard floor.
Press down the side of bristle button with
mark “ –“ and then use the bristle
retracted for hard floor.
For cleaning couch and sofa etc. it is
2in1,you could turn it for you desired By turning the speed control knob the
using. absorption power can be adjusted.
You can use turbo brush and vacuum Change the wind power control knob on
the carpet and upholstery. handle can adjust the suction.
Each time after your cleaning press the
on/off switch first and then remove the
power plug from socket. To rewind the
power cable, press the rewind button
with one hand, and guide the other hand
to ensure that it does not cause damage
when whipping.
Acoustic alarm
The indicator will become red when the
air flow is obstructed or the dust bag is
full. At that time, you should shut off the
power, and clean the block or clean out
For cleaning corner edge and draws etc the dust in the dust bag. Then switch it
where is difficult to clean. on again.
Instruction for use
Before using the appliance, unwind length
of cable and insert the plug into the power
socket. A yellow mark on the power cable
shows the ideal cable length. Do not
10