High Lift Feature crumpets) will take longer to toast,
When toasting has finished, the loading sometimes significantly longer, since
handle can be lifted to provide easier more moisture must be evaporated from
access to the toast. the bread before toasting can occur. Very
thick pieces may require two cycles.
Reheat Feature When toasting raisin or other fruit breads,
This toaster allows you to reheat toast remove any loose raisins from the surface
without toasting the bread further. To of the bread before placing into the
reheat, place the toast into the toasting toaster. This will help prevent pieces from
slots, select a low setting on the browning falling into the toaster or sticking on the
control and lower the loading handle until quard wire in the slot.
it locks into place. Finally, press the
Reheat button. The toast will pop up when Single Slice Toasting
the operation is complete. If you are toasting a single slice of bread,
NEVER attempt to reheat buttered toast. set the browning control lower than
normal. The toaster is designed to heat
Defrost Feature two toasting chambers at a time. By
Place frozen bread into the toasting slots, lowering the heat for a single slice, you
select a low setting on the browning will not over-toast.
control and press the loading handle until
it latches. Finally, press the Defrots button. CLEANING
The bread will pop up when the operation Unplug the toaster before you clean it.
is complete. Wait until your toaster has cooled down
completely before cleaning.
WARNING! Clean the outer surface with a soft damp
Never leave your toaster unattended when cloth only.
in use as toast can burn. It is important that crumbs are not allowed
to build up inside the base of the toaster.
Toasting Notes Crumbs can be removed by simply
Toasting is a combination of cooking and sliding open the crumb tray at the bottom
drying the bread. of the toaster, see below. You can then
Moisture levels differ from one bread to tip the crumbs out.
another which can result in varying Always ensure the toaster is fully cooled
toasting times. and disconnected from the mains supply
For slightly dry bread, use a lower setting before carrying out this operation.
than normal. Never touch the internal parts of the
For fresh bread or whole wheat, use a toaster with a brush or any other
higher setting than normal. implement.
Breads with very uneven surfaces will Technical Specification
require a higher setting. Power source: 230 Volts AC 50Hz
Thicker cut pieces of bread (including Power consumption: 900W
10
İlginizi çekebilecek Fakir marka Ekmek Kızartma Makinası ürünleri
