GENERAL USAGE EXPLANATION OF air distributing part (16).
THE APPLIANCE • Empty the water inside the container by
Preparation for Use tilting it towards the opposite side of the
• Fill 1,85 liters of water into the container. inlet socket . You can use the handle of the
The water level should not exceed the container.
“MAX” level indicated on the container. ( • It is strongly recommended to dump the
Add 2 part water with scaled measuring water inside the container and to wash out
cup ) any dirt that might be remaining inside the
• Fit the air distributing part (16) by sliding it container after each use.
into its slot located on the container. • It is recommended to wipe inside the
• Put the water separator (17) on the container container with a dry cloth after washed.
and place the SPONGE filter (18) on top of • You may wash the SPONGE filter under the
it. water.
• Place the motor unit (1) on the container • It is recommended that the vacuum cleaner
(5) and secure it by locking the container is stored without water inside the container.
locking/unlocking parts (6) on each side. It is best to fill the filtration water (1,5 l) right
• Connect the hose (9) to the inlet socket before the use.
located on the container (5). Attach the
extension tube (11) to the hose handle. You Warnings
can attach the accessories (12, 13, 14, 15) • Please make sure that the air distributing
directly to the hose handle without using part (16) and water separator parts (17)
any tube. are always in place when the vacuum
cleaner is operated.
Operating the appliance: • If the vacuum cleaner overturns accidentally
• After checking if the voltage meets the rated during operation, switch the unit off and
voltage, plug in the appliance. unplug immediately. Dump the water inside
• Press on/off switch (20) located on the top the container and follow the cleaning
of the appliance. procedure described in “Maintenance and
• If the water becomes very dirty during Cleaning the Appliance” section, above.
cleaning, replace it as described in the Make sure that all the parts have been dried
“Maintenance and Cleaning the Appliance” before using the appliance again.
section.
Blower Function:
• Remove the blower cover lid and insert the
hose into the opening on the body.
CAUTION : THIS APPLIANCE IS NOT A
WET&DRY VACUUM CLEANER, BUT A
DRY VACUUM CLEANER WITH WATER
FILTRATION. AVOID SUCKING ANY TYPE
OF LIQUID WITH THIS VACUUM
CLEANER.
Maintenance and Cleaning the Appliance
• To empty the water inside the container,
switch off the appliance by pushing on the
On/Off switch and disconnect the power
supply cable from the mains.
• Remove the motor unit (1) after unlocking
the container locking/unlocking parts (6)
on each side of the container (5).
• Remove the water separator (17) and the
İlginizi çekebilecek Fakir marka Elektrikli Süpürge ürünleri
