TEMPERATURE SENSOR &
INDICATION
• The temperature sensor automatically
functions whenever you switch on the
scale. It will sense the room/environment
temperature and indicate the current
temperature on the upper right corner of
the LCD.
LOW BATTERY INDICATION • Temperature range
When battery is low, “LO” will appear as (Degree oC): 0~+40oC
following (1). Please replace with new • Division: 0,5oC
battery. • Tolerance: -/+ 2oC
CAUTION NOT TO OVERLOAD CARE AND TROUBLE SHOOTING
The maximum capacity of your scale is 1. The scale is a precision instrument. Please
indicated on the display panel.(2) If the avoid heavy striking, do not keep it laden
loading exceeds the capacity by 1%, the with weights for a long period.
display will start to indicate warning 2. Do not press button heavily OR with sharp
message “ERR”. object such as pen-tip.
CAUTION SHOULD BE TAKEN NOT TO 3. When you switch on the scale after
OVERLOAD TO EXCEED THE CAPACITY pressing the button “ON/OFF”, and find
OF THE SCALE. EXCEEDING THIS MAY
CAUSE DAMAGE TO THE SCALE. nothing appear on the LCD screen. Please
ensure & check the battery is installed
ALARM TIMER and well connected. Or if battery
a. Turn on the scale. is already well installed, it may be low in
b. Press button “T-SET”, the upper left corner power, replace it with new one.
will display a bell. 4. Do not use any chemical or abrasive
c. Press “ “ or “ “ to set the time span required. solvent to clean the scale. It is
Each time pressing “ or “ will increase recommended to use soft damp cloth to
of decrease a time interval of seconds. gently wipe clean the scale once in a
d. Press button “T-SET” again to start the while. DO NOT IMMERSE THE SCALE
count down. IN WATER.
e. When timer counts down to zero “00:00”, 5. Always keep the scale far away from heat,
alarm will go off in form of a “bibbing”. I.E. stove, to keep the button from aging
The “bibbing” will go on for 30 times and which will lead to loss of function.
then automatically shut off. 6. When the scale is under weighing, keep
f. You can also press “ON/OFF” button to away from electromagnetic interference
stop the alarming. Doing this will also turn (EMI) I.E. mobile phone, to avoid unwanted
off the scale completely. interference to the accuracy.
g. During count down, you can press “TSET” 7. Please remove the battery if it is not going
to stop and clear the count down and to be used for an extended period.
reset the alarm timer. 8. This scale is only for domestic use.
10