Fakir PANE Otomatik Ekmek Yapma Makinası
Questions & Answers On Bread Baking Machines Problem Cause Solution Smoke comes out of the The ingredients stick to the Pull out the plug and clean baking compartment or of baking compartment or on the the outside of the baking tin the vents outside of the baking tin or the baking compartment. The bread goes down in the The bread is left too long in Take the bread out off the middle and is moist on the the tin after baking and baking tin before the warming bottom. warming. function is over. It is difficult to take the bread The bottom of the total is stuck Clean the kneading peg and out of the baking tin. to the kneading peg. shaft after the baking. If necessary, fill the baking tin with warm water for 30 minutes. Then the kneading pegs can be easily removed and cleaned. The ingredients are not mixed Incorrect program setting. Check the selected menu and or the bread is not baked the other settings. correctly. The START/STOP key was Do not use the ingredients touched while the machine and start over again. was working. The lid opened several timers The lid is to be opened only while the machine was if the time left on the display working. is more than 1:30 hours (only for proggrammes “1,2,3,4”) Make sure that lid was closed well after being opened. Long blackout while the Do not use the ingredients machine was working. and start over again. The rotation of the kneading Check that the kneading pegs peg is blocked. are blocked by grains,etc. Pull out the baking tin and check whether the drivers turn. If this is not the case,send the appliance to the customer service. The appliance does not start. The appliance is stil hot after Press the START/STOP The time acoustic signal goes the previous baking button until the normal off. The display shows E 01. procedure. programme appears. Pull out the plug. Take out the baking tin and leave it to cool at room tempeature.Then insert the plug and start again. “EEE” or a similar ssignal Program or electronic error. Start the test run by pulling appears on the display. out the plug, keeping the menu key pressed and inserting the plug again. Release the key. The menu performs a test run. Unplug again The normal program should appear on the display. If this is not the case, send the appliance to the Customer Service. 20