Cisco CISCO2811 Router
GigabitEthernet0/0 20.0.0.40 YESDHCP up up
GigabitEthernet0/1 unassigned NO unsetup up
GigabitEthernet0/3/0unassigned NO unsetup up
Adım 8
Enter interface name used to connect to the
management network from the above interface summary: fastethernet0/0
Adım 9
Configuring interface FastEthernet0/0:
Use the 100 Base-TX (RJ-45) connector? [yes]: yes
Operate in full-duplex mode? [no]: no
Configure IP on this interface? [yes]: yes
IP address for this interface: 172.1.2.3
Subnet mask for this interface [255.255.0.0] : 255.255.0.0
Class B network is 172.1.0.0, 16 subnet bits; mask is /16
Adım 10
The following configuration command script was created:
hostname Router
enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1
18