Bosch DKE915A Davlumbaz
INSTALLATION The cooker hood must be installed centrally over a cooking appliance. The minimum distance between the cooking surface and the metal grease filters on the underside of the hood must be at least 650mrn. To install the hood proceed as follows: 1) Drill six 8mm diameter holes at Xl-X24 and insert the plastic rawl plugs supplied as illus- trated in fig. 2 ensuring the brackets are fitted as shown in the blow up. 2) Secure the two brackets C to the wall inserting two of the screws supplied through the two holes on line Xl-X2 as illustrated in fig. 2. 3) Slide the canopy down the wall to locate the key hole over the washer then secure the can- opy to the wall by inserting two of the screws supplied through the two outer holes in the rim of the canopy Jl and J2 as illustrated in fig. 3. 4) EXTRACTION OR RECIRCULATION INSTALLATION: EXTRACTION (DUCTED) When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice ofwhich is left to the installer. To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. • Fix the pipe in position using suffcient pipe clamps (not supplied). Remove any activated charcoal filters. • RECIRCULATION (FILTERED) • When the hood is fitted in the recirculation mode the Air Outlet Connection H should be fitted as illustrated in fig. 6. Fit the (optional) charcoal filters by repeating the following operation on each side of the motor housing. Place the two key hole slots in the filter L and turn the filter clockwise to lock the filter in position as illustrated in fig. 7. WARNING: It is a possible fire hazard if the metal grease filters are not cleaned and the charcoal filters replaced regularly. Fitting The Chimney 5) FITTING THE CHIMNEY UPPER To fit the upper chimney A, place the top edge of the chimney over the bracket C as illus- trated in fig. 8 and secure the chimney using two of the 2.9mm self tapping screws pro- vided. The distance H in the height between the fixing holes Xl and X2 is determined by the height of the upper chimney A. 6) FITTING THE CHIMNEY LOWER To fit the lower chimney B, apply slight force to the two rear edges to increase the width of the apperture, then sleeve the chimney B over the chimney A as illustrated in fig. 9.