Blue House BH020G Elektrikli Süpürge
Press the unlocking button of the dust 17. Remove the filter and clean it by either
compartment lid and fold down the dust shaking it out or washing it. When washing
compartment lid. the filter, handle it with care and use warm
water. Let it dry in the air. Do not use a
Pull out the filter bridge with the dust bag detergent. The filter must be fully dry before
towards the back. reinserting it back into the appliance.
Pull the filter out of the side of the filter bridge. Reinsert the motor protection filter. Make
After removing the full filter from the filter sure that the filter is fastened centrally on
bridge, close the opening of the filter with the the suction grate.
folding tabs.
Dispose of the bag with household waste. 18. Replace the filter bridge with the dust bag
Put a new dust bag into the filter bridge. and close the lid.
Replace the filter bridge with the dust bag and ATTENTION: Never vacuum without a dust bag.
close the lid.
When do I have to change the motor
ATTENTION: Never vacuum without a dust bag. protection filter ahead of time?
When the vacuum cleaner is used improperly
Cleaning the motor protection filter such as vacuuming without a paper bag or when
It is recommended to always clean the filter the dust bag tears.
when the dust bag is changed and to replace it
with a new filter after changing the dust bag 19. Changing the HEPA Exhaust Filter
five times. Press the retaining strap for the exhaust filer
It is recommended to always clean the filer if lid to the back and lift the lid to the back.
there is an operational fault, i.e. after the dust
bag tears or after removing a blockage. 20. Pull the HEPA exhaust filter up and out of
ATTENTION: Never use the appliance without the holder. Clean the HEPA exhaust filter by
the motor protection filter in place or else the banging it out or with a soft brush.
motor could become damaged, which would Afterwards, put the HEPA exhaust filter back
not be covered by guarantee. into the appliance.
The HEPA exhaust filter must be replaced with
15. Press the unlocking button of the dust a new one after approx. 50 hours of normal
compartment lid and fold down the dust operation.
compartment lid.
16. Pull out the filter bridge with the dust bag
towards the back.
15 16
Cleaning and Service clogged. Then, the change dust bag display will
Unplug the power plug before cleaning and Show "full", even if the dust bag is not yet full.
service. The vacuum cleaner - and above all the The dust bag must then be changed, since the
dust space - and all the accessories can be cleaned suction power has been reduced by the plugged
with a soft cloth or commercial plastic cleaner. pores.
Let it dry afterwards. However, if you vacuum up a great deal of hair,
Occasionally vacuum the lower side of both floor carpet or wool fluff, etc., then the change dust
nozzles with the joint and crack nozzle. bag display may only respond when the dust
bag is already bulging full.
Other Important Information
Dust bags are disposable articles. They must not
be used multiple times because plugged pores
reduce the suction power.
To check:
• Attach the floor nozzle. Ali other nozzles
affect the functioning of the change dust bag
display.
• Switch on the vacuum cleaner and set the
suction power selector (if available) to full
suction power.
• Lift the floor nozzle off the floor by a small
amount.
• if the dust bag full display is "red", then you
must change the dust bag.
What you should know about how the change
dust bag display works.
The display is designed to work with mixed dust,
as is mainly found in the home. This includes
hair, carpet fluff, threads, sand, and so on.
However, if you vacuum up a great deal of fine
dust, for example drilling dust, sand, plaster, or
flour, the pores of the dust bag will become
18