Blue House BH016P Elektrikli Süpürgeler
Note 1: A red LED on the remote lights up Change of Filters WATER CONTAINER
when die remote is MOTOR PROTECT ION FILLER • Lift the water container out by its handle,
transmitting The air inlet filters are located underneath unhooking it from its position and remove
Note 2: The blue LED on the remote is the the appliance, which can prevent dust from the container as shown in Fig. 5
infra-red transmitter and does not light up. entering into the motor, to reach these filters, • Turn the container handle as indicated in
open the bottom filter cover which secures Fig. 6 so as to remove the filter assembly.
Using the Accessories it. While you find that there is a loss of
These accessories can .t on to the tubes or suction with the cleaner, please take out the
directly on to the end of the flexible hose inlet filters (see Fig 1 & 2)and have them
handle. The small cleaning tool is used: for washed in warm water, but before refitting,
upholstered furniture, The crevice nozzle is it is recommended that both of these filters
used for radiators, skirting boards, hard to should be dried naturally.
reach comers, etc. The brush which fits on to Attention: Do not use the vacuum cleaner
the small cleaning tool is used for lampshades without the motor protection
or polished surfaces. filter
If you wish to pause briefly during vacuuming
i.e. to move a small piece of furniture or a
rug use the special parking position on your
vacuum cleaner. Slide the hook attached to
the large cleaning tool into the slot on the
rear of the appliance.
When you have finished vacuuming, press
the pedal to stop the appliance then unplug
it at the mains and press your foot on the
pedal to automatically rewind the cord,
AIR OUTLET FILTER
Filters the aer which is see Fig 3 & 4 expelled.
Pull on its holding clip to take it out of its
housing. When fitting the new filter, make
sure to secure it correctly with the clip.
15
• Fili the water container with water until • Reassemble the filter assemble by Address to service center for consultation,
the MAX level indicator (at the back of repeating the operation in the reverse when the service life of product has expired.
water container) is reached. order. Otherwise the further operation can entail
• Replace the filter assembly back in the impossibility of normal use of the product.
water container
• Replace the water container by holding
the handle and guiding it back into
position until it hooks into place. Your
product is now ready for use.
DUST BAG INDICATOR
When dust is full, buoy in the dust container • Never put the appliance in water
moves up automatically and clog the air inlet. • Do not touch the plug or the vacuum
In this situation, it has no ability of suction. cleaner with wet hands
You need to cut off the power, and dispose • Do not use your vacuum cleaner outside
the dirt water, then you can use it again. the house
• Do not use the vacuum cleaner on animals
PRODUCT CARE AND STORE • Do not suck up inflammable liquids such
Cleaning and maintenance of the Filter as cleaning fluids, gasoline etc.or their
Assembly vapours.
• It is highly recommended that you pour • Do not use the cleaner if there is any
away the dirty water and clean obstruction in it's passages, for this may
the container and the filter assembly after dangerously overheat the motor.
each use. • Please be careful with the cord so that it
• Lift the container handle, remove the filter does not become a tripping hazard.
and pour away the dirty water. • Please pay attention while cleaning stairs.
• Pull the elbow tube away from the filter • If the supply cord is damaged, please take
body until it is removed the unit to an authorized service center to
• Separate all the components and rinse replace it with a new cord made by the
them under running water. manufacturer.
• Before putting the sponge filters back,
wring them by using a cloth so as to dry
them perfectly.
18