• When the filter is dry, replace into theunit and IMPORTANT • To separate the debris screen fromthe dust cup,
replace the HEPA filter anddust cup container. Please Note: hold the dust cup inone hand and turn the dust
• A severely soiled or clogged filter should be The "TapClean" HEPA Filter will stop most of the cup cover counter clockwise and pull apart.
thoroughly washed withfresh tepid water. A mild tiniest dust particles and airborne allergens from re- To clean the debris screen, we recommend that
detergentcan be used if required. entering the air you breathe. In fact it stops 99.97% you rinse it under lukewarm running water to
of all particles as small as 0.3 microns - many times remove the dirt that accumulates on it, but always
Changing & Cleaning the Post Motor Filter smaller than a human hair!!! Because of this allow it to completely air dry before inserting
The post motor filter is a washable filter but should incredible filtration performance, the HEPA Filter back into the vacuum.
be replaced every three (3) months. will quickly accumulate, Inside the white filter folds,
• Remove the filter cover from the frontof the unit many fine dust particles that are difficult to see but WARNING: Always remove the power plug from the
and remove the filter. which will eventually block or reduce your suction wali outlet before assembling or removing
• Rinse the post motor filter in lukewarmwater and power - if not cleaned properly. accessories.
air dry the filter completelyfor 24 hours. Do not • To remove the dust cup container, first press on
use a washingmachine to rinse the filter. Do the dust cup release button that is located on EXTENDING THE TELESCOPIC TUBE
notuse a hair dryer to dry it. Air dry only.Never the dust cup handle and at the same time press Push the plastic button and pull out the smaller
operate the vacuum without thepost motor filter on the dust cup release button that is on the tube.
in place. side of the upper housing. Then pull the dust cup
• When the filteris dry, replaceinto the filter container out. INSERTING THE TELESCOPIC TUBE INTO THE MAIN
coverand replace the filtercower to the unit. • To empty the dust cup container, press on the UNIT
• A severely soiled or clogged filter should be trap door release button that is on the back side • Insert the telescopic tube into the holenext to
thoroughly washed with fresh tepid water. A mild of the dust cup container. the dust cup handle. Make surethat the slot in
detergent can be used if required. • The HEPA filter is located underneath the the handle fits correctly into the opening.
dust cup container. Remove the Non-Woven Pre- • To remove the telescopic tube, pressthe telescopic
OPERATING INSTRUCTIONS Filter. Remove the HEPA filter, hold the edges tube release button andpull the tube up.
Emptying the Dust Cup Container and Cleaning / and pull it out slowly.
Changing the Non-Woven Pre-Filter, HEPA Filter & • Hold the HEPA filter by the edges and vigorously ATTACHING THE FLOOR BRUSH TO THE MAIN
Debris Screen "TapClean" the HEPA Filter dirty side down on a UNIT
hard, flat surface until no more dust is observed • Insert the floor brush into its location,in the
warning: Always unplug the unit from electrical falling out from between the pleats of the filter. direction of the arrow.
outlet before opening the Dust Cup (container). We recommend washing the HEPA filter once a • To remove the floor brush from themain unit,
month or when suction appears to be reduced. press on the floor brushrelease button and pull
important Do NOT use the vacuum without the HEPA Let the HEPA filter air dry completely for 24 hours. the floor brushout.
filter in place. • Rinse the non-woven pre-filter and letair dry
completely for 24 hours. ATTACHING THE HOSE TO THE MAIN UNIT
warning: After each Use -Always remove Filter • Insert the non-woven pre-filter. • Hold the end of the hose.
Assembly and the Dust Cup Cover with the Debris • Reinstall the HEPA filter in the vacuum. • Insert the hose into the hoseconnector.
Screen, then vigorously "TapClean" HEPA Enter and
clean Debris Screen and Non-Woven Pre-Filter until
no more dust can be removed.
16
OPERATING INSTRUCTIONS WARNING Important: In order to ensure that maximum air
After extended use, the body of the vacuum cleaner suction is maintained, empty the dust cup frequently
WINDING & UNWINDING THE POWER CORD may become hot. When using the unit with the and shake out the HEPA filter and clean the non-
This vacuum cleaner is equipped with a convenient shoulder strap, the unit will touch the body of the woven pre-filter and debris screen at the same time.
cord storage feature. The power cord winds around user. Therefore, make sure that the unit body is cool
the two cord holders at the back of the unit. The before you use with the shoulder strap. if during
bottom one has a quick cord release feature. Turn use, the vacuum gets too warm, allow it to cool
the cord hook to the left or the right to remove the before continuing to use.
power cord.
Crevice Tool
ON/OFF SWITCH For radiators, crevices, corners, baseboards and
The On/Off switch has two different between cushions.
positions.
Push on the "I" side to turn the vacuum ON. Dusting Brush
Push on the "O" side to turn the vacuum OFF. fhe dusting brush is used for the furniture, venetian
blinds, books, lamp shades and shelves.
USING THE UNIT AS AN UPRIGHT
• Unwind the power cordand plug into theV outlet. Intelli-SenseTM Filter Monitor
• Push down on thelocking button to adjustthe When the Intelli-SenseTM Filter Monitor lights up,
height of thetelescopic handle. it means that the dust cup is full or the HEPA filter,
non-woven pre-filter or debris screen needs cleaning.
NOTE: When vacuuming deep pile carpets or hard You must empty the dust from the dust cup and
to vacuum carpets lower the angle of the telescopic clean the HEPA filter, non-woven pre-filter and
handle (see illustration at right) for easier debris screen right away.
maneuverability.
USING THE UNIT AS A HAND VACUUM
• Press the telescopic tube releasebutton to remove
the telescopic tube.
• Press the floor brush release button toremove
the floor brush.
• Attach the shoulder strap to theshoulder strap
attachment point.
• Attach the crevice tool or the dustingbrush to the
end of the hose.
17
İlginizi çekebilecek Blue House marka Elektrikli Süpürge ürünleri
