Safety Instructions
For household use only!
When using your vacuum, basic safety precautions
should always be observed, including the
following
Do not leave vacuum cleaner unattended when
it is plugged in. Unplug from outlet when not
in use and before pulling filters out.
2.
To reduce the risk of electric shock-do not use
outdoors or on wet surfaces.
Do not allow children to use as a toy. Close
3.
attention is necessary when used near children.
Use only as described in this manual. use only
4.
manufacturer's recommended attachments.
5. Do not use with damaged cord or plug. Do
not use vacuum cleaner if it has been dropped
damaged left outdoor or dropped into water.
Return appliance to the appliance customer
service for examination repair or adjustment.
Do not pull or carry by cord. Does not use cord
6.
as a handle. Close a door on cord, or pull cord
around sharp edges or corners. Do not run
appliance over cord. Keep cord away from
heated surfaces.
Do not unplug by pulling on cord. To unplug,
7.
grasp the plug, not the cord.
8.
Do not handle plug or vacuum cleaner with
wet hands. Dot not use outdoors or on wet
surfaces.
9.
Do not put any objects into openings. Do not
use with any openings blocked and do not
restrict airflow. Keep all opening free Of dust,
lint, hair, and anything that may reduce airflow.
Fitting the Floor Brush to the tube. push the
4.
tube into the floor brush. Adjust the tube to
the desired length.
Variable suction control
Note: Once all attachments are in place, unwind
a sufficient length Of cable and insert the plug
into the wall outlet. A yellow mark on the power
cord shows the ideal cable lenghth. Do not pull
the power cord beyond the red mark.
1. Insert the power plug into the wall outlet.
2. Press the power on/off button located the unit
to turn the vacuum cleaner "on".
3. To rewind the power cord, press the cord
rewind button with one hand and guide the
power cord with the Other hand to ensure that
it dose not whip causing damage or injury.
4. To adjust the suction, slide the speed control
button on the suction hand to control the
suction power of the vacuum cleaner.
Motor thermostat
Important:
This motor is equipped with a motor protective
thermostat. If for some reason the vacuum cleaner
should overheat, the thermostat will automatically
turn the unit off. Should this occur unplug the
vacuum cleaner from the wall Outlet and turn
off switch, change dust bag and clean filters.
Allow the unit to cool for approximately 1 hour.
TO restart, replug into wall Outlet and turn switch
back on.
9
10. Keep hair, loose clothing, fingers, and all parts
of body away from openings and moving
parts.
11. Do not pick up hard or sharp objects such as
glass nails, screws, coins, etc.
12 _ DO not pick up hot coals, cigarette, matches
or any hot, smoking, or burning objects.
13. Do not use without filters in place.
14. Turn off all controls before plugging or
unplugging vacuum cleaner.
15. Use extra care when vacuuming on stairs.
16. DO not pick up flammable or combustible
materials (lighter fluid, gasoline, etc.) or use
in the presence of explosive liquids or vapor.
17. DO not pick up toxic material (chlorine bleach,
ammonia, drain cleaner, etc.)
18. Do not in an enclosed space filled with vapors
given Off by Oil based paints, paint thinner,
moth proofing, flammable dust, or other
explosive or toxic vapors.
19. Always unplug this appliance before
connecting or disconnecting vacuum hose.
Do not allow plug to whip when rewinding.
20. Use only on dry, indoor surfaces.
21. Do not use for any purpose other than
described in this user's guide.
22. Store your appliance indoor in a cool, dry
area.
23. Keep your work area well dry.
24. DO not immerse the hand vacuum into water
or other liquids.
25. Keep end of hose, wands and other openings
away from your face and body.
26. Do not use the cleaner to clean your pets or
any animal.
Change dust bag.
1. Open the front cover.
2. Change dust bag.
Carry and move away the cleaner:
Note: This cleaner have a special feature for
handle. You can use it to conveniently carry the
cleaner when the cleaner is in vertical
And also have 3 small direction wheels at the
bottom for easy movement on the floor.
27. Keep the head (eyes, ear, mouth, etc.) away
from the openings, when the cleaner is
working or plugging.
WARNING:
Important:
If the suction opening of the unit, the hose or
the tube is blocked, switch off the vacuum clearer
and remove the blocking substance before you
start the unit again.
1. Do not operate the vacuum cleaner too close
to hearter Or radiators.
2.
Before inserting the power plug into the wall
outlet, make sure that your hands are dry.
Before you start the unit, make sure to remove
3.
large or sharp objects that might damage the
dust tank and hose.
When pulling out the power plug from the
4.
wall outlet, pull the plug not the power cord.
5. Do not use without all filters in place.
When using, if you learn Of squeak from the
6.
cleaner, it must be suction appears to be
reduced, so you must stop (make sure the
cleaner is not plugging), then clean the all air
filter.
Note: If the supply cord is damaged, it must be
replaced by manufacture, service agent or similarly
qualified person in order to avoid a hazard
Removing & cleaning pre-motor filter and
air outlet filter
Warning: A [ways unplug the unit from electrical
outlet before getting out the dust barrel.
a. Pre-motor filter
1. Open the front cover.
2. Bring Out the inlet filter grill and clean or
change filter.
b. Air outlet filter
1. press the front cover lock knob to open it
2. Take out the air outlet filter for clean and
change.
Please note:
The sponge filter material in the cleaner will
became dusty over time. This is normal and will
not affect the performance Of the filter. If the
sponge filter is so dusty that suction does not
WARNING: Hold the plug when rewinding the
cord. Do not allow the cord to whip when
rewinding.
Use and function
Assembling vacuum cleaner
Note: Always remove the power plug from the
wall outlet before assembling or removing
accessories.
1. Attaching the Flexible Hose into the vacuum
connect the flexible hose into the air intake
duct, push in until you hear a "click", indicating
it is in its locked position.
2.
Fitting the tube to the curved wand/hose
extension. Push the tube into the curved
wand/hose extension.
3 . Attaching the small brush and small crevice
on the handgrip by using the connector
return to 100%, then we suggest that the filter
be removed then rinsed under the faucet and
allowed to dry for 24 hours by airing not near
the fire or some high temperature objects before
refitting into the vacuum. This should be done
once six months or when suction appears to be
reduced obviously.
Important: Please note that there is a safety
switch inside the vacuum to prevent the unit from
being run with high vacuum rate. If the vacuum
is too high , the safety switch will be turned on.
In this case, it can minish the vacuum rate and
protect the motor from being broken.
Note: The suction hole must be open, free Of any
obstructions at al/ times. Otherwise, the motor
will overheat and could become damaged
Important: All filters should be checked regularly
for signs of damage, preferably after each
cleaning task. The filters must be replaced
immediately if they become damaged. Always
disconnect the vacuum from the electrical outlet
when checking the filters.
When the suction hole is blocked ( hose or
telescobic tube) or if air outlet filter needs to be
cleaned and thus the internal temperature Of the
Motor rises, the thermostat protector will cut Off
the power in order to protect the motor.
Afterwards, after trouble shooting and the motor
temperature will return to normal, it will rerun.
Thermostat Protector protects the Vacuum Cleaner
against Motor burning risks.
10
