the product to the electric system. In case
this problem repeats again or if the product
does not start again, take the product to the
nearest After Sales Service Point
STABILITY
AWARNING: The machine must be always kept
on horizontal bases, in a safe and stable way.
USAGE
DESCRIPTION OF THE MACHINE
the specific instructions
See
provided.
ASSEMBLY INSTRUCTIONS
the specific instructions
See
provided.
PUT INTO SERVICE
see fign
STARTING UP
See figß
HIGH PRESSURE LANCE
see
DETERGENT SUCTION
See figE
HIGH PRESSURE HOSE
See fig"
WATER SUPPLY
Water supply collection
Water su I from the water main
manual
manual
Connect a supply hose (not included) to
the water inlet of the unit and to the water
supply.
Open the water supply.
WARNI NG: (sym bol) machine not suitable
for connection to the potable water mains.
The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a
backflow preventer. Make sure that the hose
is at least Ø 13mm-1/2 inch and that it is rein-
forced.
A WARNING: Water that has flown through
backflow preventers is considered to be
nonpotable.
L&IMPORTANT: only clean or filtered water
should be used for intake. The delivery of
the water intake tap should be equal to the
double of the maximum pump range.
- Minimum delivery rate: 15 1/ min.
- Maximum intake water temperature: 400C
- Max inlet water pressure: 1 Mpa
Place the cleaner as close to the water supply
system as possible.
Water su I from ano en container
Unscrew the coupling part for the water
inlet.
Screw the suction hose with filter (not
included) onto the water connection of the
unit.
Hang the filter in the container.
• Vent the unit before operation.
Unscrew the high-pressure line at the high-
pressure outlet of the unit.
Switch on the unit and let it run until water
free of bubbles emerges at the high-pressure
outlet.
• Switch off the unit and screw on the high-
pressure hose again.
Failure to comply with the above conditions
causes serious mechanical damage to the
pump and the loss of warranty cover.
ELECTRICITY SUPPLY
The appliance's electrical connection must
comply with the IEC 60364-1 standard.
IMPORTANT: Before connecting the
appliance, make sure that the nameplate
data are the same as those of the electrical
mains and that the socket is protected by a
differential security breaker with tripping
sensitivity below 0.03 A - 30 ms.
- If the appliance's plug is not compatible with
the socket, have the socket replaced with
another Of suitable type by professionally
qualified staff.
Never use the appliance in ambient
temperatures below 00 C if it is equipped
with a PVC (H VV-F) cable.
9