Lavor Tormenta 28 Yüksek Basınçlı Yıkama Makinesi
the product to the electric system. In case this problem repeats again or if the product does not start again, take the product to the nearest After Sales Service Point STABILITY AWARNING: The machine must be always kept on horizontal bases, in a safe and stable way. USAGE DESCRIPTION OF THE MACHINE the specific instructions See provided. ASSEMBLY INSTRUCTIONS the specific instructions See provided. PUT INTO SERVICE see fign STARTING UP See figß HIGH PRESSURE LANCE see DETERGENT SUCTION See figE HIGH PRESSURE HOSE See fig" WATER SUPPLY Water supply collection Water su I from the water main manual manual Connect a supply hose (not included) to the water inlet of the unit and to the water supply. Open the water supply. WARNI NG: (sym bol) machine not suitable for connection to the potable water mains. The cleaner can only be connected to the wa- ter mains if the water mains is separated by a backflow preventer. Make sure that the hose is at least Ø 13mm-1/2 inch and that it is rein- forced. A WARNING: Water that has flown through backflow preventers is considered to be nonpotable. L&IMPORTANT: only clean or filtered water should be used for intake. The delivery of the water intake tap should be equal to the double of the maximum pump range. - Minimum delivery rate: 15 1/ min. - Maximum intake water temperature: 400C - Max inlet water pressure: 1 Mpa Place the cleaner as close to the water supply system as possible. Water su I from ano en container Unscrew the coupling part for the water inlet. Screw the suction hose with filter (not included) onto the water connection of the unit. Hang the filter in the container. • Vent the unit before operation. Unscrew the high-pressure line at the high- pressure outlet of the unit. Switch on the unit and let it run until water free of bubbles emerges at the high-pressure outlet. • Switch off the unit and screw on the high- pressure hose again. Failure to comply with the above conditions causes serious mechanical damage to the pump and the loss of warranty cover. ELECTRICITY SUPPLY The appliance's electrical connection must comply with the IEC 60364-1 standard. IMPORTANT: Before connecting the appliance, make sure that the nameplate data are the same as those of the electrical mains and that the socket is protected by a differential security breaker with tripping sensitivity below 0.03 A - 30 ms. - If the appliance's plug is not compatible with the socket, have the socket replaced with another Of suitable type by professionally qualified staff. Never use the appliance in ambient temperatures below 00 C if it is equipped with a PVC (H VV-F) cable. 9