A XY WARNING: Inadequate extension cords
can be dangerous.
XJ WARNING: If an extension cord is used,
the plug and socket must be of watertight
construction.
Information for supply may also be obtained
from the plug manufacturer.
20 m - 50 m
PLUG
16A
ø 1,5 mm2
14 AWG
ø 2,5 mm2
12 AWG
ø 2,5 mm2
12 AWG
ø mm2
IOAWG
HOW TO CONNECT THE CORD TO A U.K. PLUG:
urIMPORTANT The wires in the mains lead are
coloured in accordance with the following
code:
Blue
Brown
Yellow/Green
L
Neutral
Live
Earth
Please read the in-
structions given
below before con-
necting the cord to
a plug. If in doubt
please consult a
qualified electri-
cian. As the colours
of the wires in the
mains lead of this
appliance may not
correspond with
the coloured mark-
ings identifying the
terminals in your plug, proceed as follows:
The wires that is coloured Brown must be con-
nected to the terminal which is marked with
the letter L or coloured Red. The wire that is
coloured Blue must be connected to the ter-
minal which is marked with the letter N or col-
oured Black.
Safety points for rewireable or moulded plug:
The mains lead of this appliance may be already
fitted with a BS1363 13A plug.
- If your socket outlet is not suitable for the
plug, then the plug must be removed (cut
off if it is a moulded on plug), the flexible
cord insulation should be stripped back as
10
appropriate and a suitable 3 pin plug fitted.
A WARNING: Dispose of a plug that has been
cut from the power supply cord, as such
a plug is hazardous if inserted in a live 13A
socket outlet elsewhere in the house.
- Should the fuse need to be replaced an ASTA
marked fuse, approved to BS1362, of the
same rating must be used.
- Always replace the fuse cover after fitting
a fuse. The plug must NOT be used if the
cover is omitted or lost until a replacement
is obtained.
- Make certain that only the correct fuse cover
is used and fitted.
- For plugs with detachable fuse cover the
replacement must be the same as the colour
insert in the base Of the plug, or as directed
by the embossed wording on the base of the
plug.
- If the detachable fuse cover is lost a
replacement may be purchased from a
Service Centre.
A.S.S
• ( if fitted)
NOTE: ASS. (Automatic Stop System),
which stops the machine during the
bypass phase. To start the water cleaner, it
is therefore necessary to set the switch on
position after that press the pistol
trigger: the Automatic Stop System will start
the machine and will stop it automatically
when the trigger is released. It is advisable
to put on the safety of the pistol trigger
whenever the machine is stopped, in order
to avoid unintentional starting.
Any automatic start of the machine without
pressing the gun trigger is attributable to
air bubbles in the water or other similar
phenomena which do not imply the
existence of any defects in the machine.
Do not leave the appliance unattended
during the standby for more than 5 minutes.
Contrarily, for the safety of the appliance it
is necessary to re-turn the switch into the (O)
OFF position.
• Please check that the coupling of the high
pressure hose with the appliance and the
gun supplied as standard equipment made