* LCA 52 66 242 7 * YAMAHA * RJ14 * 2002/24 * -- * Page 32
2.2.1.16. Single Directive 97/24/EC, Chapter 3
2.2.1.16.1. Title
External projections from two- or three-wheel motor vehicles
2.2.1.16.2. General requirements
The external surface of the vehicles does not exhibit any parts or any
projection to be likely either to increase the risk or seriousness of body
lesions suffered by any person struck or grazed by the vehicle in the event
of an accident.
All parts of the external surface of the vehicle, which graze the testing
device have a radius of curvature of at least 3 mm for corners and 0,5 mm
for edges in the case of plates. Stems have a diameter of at least 10 mm and
their edges are at least 2 mm.
The edges and corners of parts of the external surface of the vehicle, which
collide with the testing device have a radius of curvature of at least 2 mm in
the case of plates. In the case of stems they are not longer than half the
diameter, if these stems have a diameter of less than 20 mm. The edges of
stems have a radius of curvature of at least 2 mm, if the stems diameter is
more than 20 mm.
2.2.1.16.3. Particular specifications
2.2.1.16.3.1. Windscreen or fairing
For all versions of variant I and III:
The upper edge of the windscreen has a radius of curvature of at least 2 mm.
For all versions of variant II and IV:
not applicable
2.2.1.16.3.2. Clutch and break levers
The ends and outer edges of the clutch and brake levers are spherical and
have a radius of curvature of more than 7 mm.
2.2.1.16.3.3. Front mudguard
The leading edge of the front mudguard has a radius of curvature of more
than 2 mm.
2.2.1.16.3.4. Fuel tank filler cap
The rear edge of the fuel tank filler cap extends not more than 15 mm above
the underlying surface. The underlying surface is smooth or perceptively
spherical.
...