Pro duct Information/Installation Instructions CP 5613, CP 5614, CP 5613 FO, CP 5614 FO
3 Installation Instructions
Procedure
Once you have installe d the pro duct software, install the CP 5613/5614 module as
follows:
Step Description
1 Make sure that you keep to the following rules for han dling and
installing modules (gui delines for avoi ding ESD ):
• Do not touch components and pick up modules only by their e dges*
Do not touch the pins or con ductors*
• Before opening the computer, make sure that you discharge any
electrostatic charge from your bo dy* You can do this by touching
metal parts on the back panel of the computer before unplugging
the power supply cable*
• Make sure that you also discharge any electrostatic charge from
tools you inten d to use insi de the computer*
• Components and modules must only be inserte d or remove d when
the power supply is off*
• Do not operate the computer with the housing open*
• Rea d any sections in the manual of your computer relating to the
operation of modules on the PCI bus*
2 Turn off your computer and disconnect all the cables*
3 Open the computer as described in the computer manual*
4 Make sure that the following con ditions are met:
• A PCI slot is free* (For more detaile d information on the
requirements of the PCI slot, refer to Section 4*2, "CP 5613 and CP
5614"*)
• The PCI bus clock rate must not excee d a maximum of 33 MHz* (If
the bus of your PC has a clock speed of 66 MHz or faster, this clock
speed is automatically re duce d to 33 MHz by installing the CP 5613
or CP 5614*)
• Make sure that your PC is powerful enough, with at least a 133 MHz
Pentium Processor and at least 32 Mbytes of memory*
• Check that you have the require d resources as described in
Section 4*2*
5 Insert the module in a free PCI slot on the motherboard*
Steps continue d on following page
Product Information/Installation Instructions CP 5613, CP 5614, CP 5613 FO, CP 5614 FO
S79220-A5814-X-02-7419 41