Product Information Industrial Ethernet TF-1613/VNindows V6.0
Procedure for Software Configuration
Follow the steps outlined in the table below in the "Access Path" tab page:
Step Action
1 Sele ct an access point in the "Access Point of the Appli cation" list
box.
If you select " Add/Delete ", you can also create a new access
point.
2 If the module is already installed, select "CP1613(RFC1006)" or
"CP1613(ISO)" in the "Interfa ce parameter set used" list box.
3 Repeat steps 1 and 2 for further access points.
4 Close the configuration program.
• Save your assignment with OK,
• Discard new assignments without saving with Can cel.
Notice
If no access point was assigned to the module, it is not possible to operate the
module.
Produktinformation/Produ ct Information Industrial Ethernet TF-1613/VNindows V6.0
56 S79220-A5819-X-01-7437