Questions & Answers on Bread Baking Machines
PROBLEM CAUSE SOLUTION
Smoke comes out of the The ingredients stick to the Pull out the plug and clean the outside
baking compartment or of the baking compartment or on the of the baking tin or the baking
vents outside of the baking tin compartment.
The bread goes down in the The bread is left too long in the Take the bread out of the baking tin
middle and is moist on the tin after baking and warming. before the warming function is over.
bottom.
It is difficult to take the The bottom of the loaf is stuck Clean the kneading hooks and shaft
bread out of the baking tin. to the kneading peg. after the baking. If necessary, fill the
baking tin with warm water for 30
minutes. Then the kneading pegs can
be easily removed and cleaned.
The ingredients are not mixed Incorrect program setting. Check the selected menu and the
or the bread is not baked other settings.
correctly. The START/STOPP key was Do not use the ingredients and start
touched while the machine was
working. over again.
The lid opened several timers The lid is to be opened only if the time
while the machine was working. left on the display is more than 1:30
hours (only for programmes „1, 2, 3,
4“). Make sure that lid was closed well
after being opened.
Long blackout while the Do not use the ingredients and start
machine was working. over again.
The rotation of the kneading peg Check that the kneading peg are
is blocked. blocked by grains, etc. Pull out the
baking tin and check whether the
drivers turn. If this is not the case,
send the appliance to the customer
service.
The appliance does not start. The appliance is still hot after Press the START/STOPP button until
The time acoustic signal goes the previous baking procedure. the normal programme appears. Pull
off. The display shows E 01. out the plug. Take out the baking tin
and leave it to cool at room
temperature. Then insert the plug and
start again.
“EEE” or a similar signal Program or electronic error. Start the test run by pulling out the
appears on the display. plug, keeping the menu key pressed
and inserting the plug again.
Release the key. The menu performs
a test run. Unplug again and then plug
in again. The normal program should
appear on the display. If this is not
the case, send the appliance to the
Customer Service.
23