ATTENTION: Do not vacuum without the • Remove the filter holder with air inlet filter(1).
dust bag. Your first flip the filter holder forwards and
ATTENTION: Replace the dustbag when then pull the filter up and out.
the vacuum cleaner is not connected to the
mains.
• Remove the air inlet filter(1) from the filter
• Remove the hose from the air-inlet. holder(2).
• Open the dust compartment cover (1) by • Clean the filter holder.
unlatching and susequently raising it up to • ‹nsert the new new air inlet filter into the
the highest position until it locks byself. filter holder.
Note: Be careful when removing the dust • ‹nsert the filter holder with new air inlet filter
filter bag so that no dust escapes! into its bracket from nabove and push it
down until it audibly locks into place.
• Replace the dust filter bag and close the
dust compartment cover. The cover clicks
audibly into place.
ATTENTION!!! This filters are not washable.
The exhaust filter may be not re-used.
AIR-OUTLET FILTER REPLACING
• Pull the dust filter bag (1) up and out of the • Switch off the vacuum cleaner and open
dust filter holder. the vacuum cleaner such way as in case
• Remove any dust that have may collected of dust bag replacing.
in the dust compartment.
• Push the new dust filter bag in the filter bag
holder.
• Close the dust compartment cover. ‹t clicks
into place audibly.
Note: The dust compartment cover can
only be closed with a dust filter bag in
place!
• Remove the exhaust filter(1). Unlatch the
AIR-INLET FILTER REPLACING lock and slightly lift the filter.Now you can
• Switch off the vacuum cleaner and open pull out the filter towards the front.
the vacuum cleaner such way as in case • ‹nsert a new filter push it down slightly until
of dust bag replacing, it locks into the holder.
• Replace the dust filter bag and close the
dust compartment cover. The cover clicks
audibly into place.
Note: Make sure that the exhaust filter is
always properly locked into position,
otherwise the exhaust air will be not properly
filtered.
11