D-H.E.P.A. OUTLET FILTER F-End of operation cleaning and maintenance
The vacuum cleaners are equipped with an H11 outlet 1- Switch off the vacuum cleaner by pressing the
fi lter H.E.P.A. (High Effi ciency Particulate Air). The “on/off”button (7).
H.E.P.A. fi lter has been designed to maximize its fi 2- Unplug the appliance.
ltration capability through special fi bers, which are able 3- Wind the cord by pressing the cord rewind button
to retain almost all dust particles. The H11 class determines (4). While doing this hold the cord to make sure it is
the permeability of a fi lter. The H.E.P.A. H11 fi lter not tangled and the plug does not hit the vacuum
retains 95,5% of particles of 0.3 micron. cleaner housing.
1- To replace the H.E.P.A. fi lter lift the vacuum cleaner 4- Disconnect the telescopic tube from the nozzle or
handle and open the accessory compartment. brush.
2- Grab the fi lter cover by the fastening, fi rmly pull with 5- Disconnect the telescopic tube from the hose.
the thumb and lift it upwards 6- Press the two side buttons on the end of the hose and
3- Remove the H.E.P.A. fi lter case and replace it with remove the hose end from the inlet opening of the
a new one. The H.E.P.A. fi lter ensures an effective vacuum cleaner.
operation of the vacuum cleaner for about 1 year. 7- The vacuum cleaner may be stored vertically or
4- Insert the cover so that the two protrusions in the lower horizontally. In order to do so, insert the fastening
part of the cover are inserted in the openings of the hook of the combination brush to the combination
vacuum cleaner body, press the fi lter cover so that brush fastener. The hose may be attached to the
the rear fastenings snap shot on the body. vacuum cleaner, however you have to make sure that
it is not excessively bent during storing.
E-INLET FILTER 8- If necessary wipe the housing and the dust bag
1- Release the upper cover fastening (12) and open the container with a damp cloth (it may be soaked with
cover. dishwashing liquid) and dry it or wipe until dry.
2- Remove the SAFBAG dust bag module (18) from the Do not use abrasive detergents or solvents.
vacuum cleaner chamber.
Slide the inlet fi lter casing with the installed inlet fi lterEnvironment Protection
3- from the tracks on the back side of the vacuum cleaner Each user can protect the natural environment. It is
chamber.
neither difficult nor expensive. In order to do it:
4- Remove the inlet fi lter (16) from the inlet fi lter casing.
put the cardboard packing into recycling paper container.
5- Place the new fi lter in the inlet fi lter casing (17) with
the material side directed towards the inside of the put the polyethylene (PE) bags into container for plastic.
casing. When worn out, dispose the appliance to particular
6- Slide the inlet fi lter casing (17) together with the fi disposal centre, because of the dangerous elements of
lter in the tracks until stop to the previous position. this appliance, which can be hazardous for natural
environment.
Please do not dispose this vacuum cleaner into domestic
ATTENTION! waste disposal!!!
Always replace a damaged inlet fi lter (16)
with a brand new, original one.
7- Insert the SAFBAG dust bag module to the vacuum
cleaner chamber.
8- Close the cover by pressing it until you hear
a characteristic click – pay attention not to trap the
dust bag.
06