This product contains batteries and recyclable electronic waste To protect the environment,
do not dispose Of it in the household Waste, but take it to appropriate local collection points.
Herzog Phillips SG Addressing concerns about fever. Clin Pediatr {Phila) 20 Il
Sund-Levander M. Forsberg C. Wahren LK. Normal oral, rectal, tympanic and axillary bod
temperature in adult men and women: a systematic literature review. Scand J Caring Sci 2602
Guidance and manufacturer's declaration — electromagnetic emissions
The PRT2000 equipment is intended for use in the electromagnetic environment specified
below.
The Customer or the user Of the PRT2000 Should assure that it is used in such an environment,
Guidance and manufacturer'S declaration — electromagnetic immunity
The PRT200C is intended for use in the electromagnetic environment specified below.
The customer or the user of the PRT2000 should assure that it is used in such an environment.
Emissions Test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuations /
flicker emissions
Group I
Class B
Not Applicable
Not Applicable
Electromagnetic environment — guidance
The ME equipment uses RF energy only for its
internal function. Therefore, its RF emissions are
Very low and are not likely to cause any interfer-
ence in nearby electronic equipment.
Complies
The ME equipment is
solely battery pmvered.
Non—Life Support Equipment Separation Distance Calculation
(3Vrms 13V/m compliance)
Separation distance according to frequency Of transmitter
Rated maximum
output power of
transmitter (W)
150 kHz to 80 MHz
in ISM bands
80 MHz to 800 MHz
0.12
800 MHz to as GHz
u test
Electrostatic dis-
charge
IEC610004-2
Radiated RF
'EC61000-4-3
Conducted RF
IFC610004-6
Electrical fast
transient
'C 610004-4
Surge
'EC61000-4-5
Power frequency
magnetic field
Voltage dips, Short
interruptions and
voltage On
power supply input
lines
ICC 10004-1
IEC 60601 test
±6kV Contact
±8kv Air
3 Wm goMHz to
2.5CHz
3Vrms 150kHzto
80MHz
±2kV power line
I/O lines
differential
±2kV common
395% dip 0.5 cycle
dip 5 cycles
dip 25 cycles
dip 5 Sec,
Compliance
level
Complies
Complies
Not Applicable
(no electrical
cabling)
Not Applicable
Not Applicable
Complies
Not Applicable
Electromagnetic environ •
ment — guidance
Floors should be wood.
concrete, or ceramic tile,
If floors are covered with
synthetic material, the
relative humidity should be
at least
Field strengths outside
the Shielded location
from fixed RF transmitters,
as determined by an
electromagnetic site survey,
Should be less than 3
Interference may in
the vicinity of equipment
marked With the following
symbol:
Separation distance
calculation provided above.
If a known is
present the specific distance
Can be calculated using the
equations
The ME equipment
is SO lely battery powered.
power fre q
magnetic fields should be at
levels characteristic Of a
typical location in a typical
commercial Or hospital
environment
The ME equipment
is solely battery