Sinbo Sinbo SK-7373 Kettle
* Fill the water heater between maximum and minimum levels as indicated in the water level indicator. Note: Do not try to fill the water heaterwhen the power cord is installed (in 'On' position). Do not use the appl ance for anything other than boiling water. Other liquids will contaminate the interior of water heater. Do not fill the appliance over the Max level indicated on water level indicator. Overfilling may cause water to spill over during boiling. * Push On / Off button to switch to •on' position. Control light will turn on indicating that the water heater is in boiling phase. When water is boiled start button will automatically switch to 'Off' position and control light will turn off. If you wish to use the water heater again, allow heat safety circuit to cool down for 150 20 seconds and then switch on / off button to On positiom If on/off button is not in •on' position. water is hot enough to be used without reOheating. * After your water heating process is done, unplug the device. Since the lid and surface will be hot, hold the water heater only by its handle. * After use, leave the water heater on a heat proof surface. • If the water heater accidentally turns on when empty, heat adjuster will automatically turn off the device in order to prevent it from overheating. If this is the case, unplug the power cord and allow water heater to cool down before refilling. * When the device is not used, it is recommended that the power cord is unplugged. MAINTENANCE AND CLEANING pull the plug out before cleaning. Empty the water inside and wait for water heater to cool down * If necessary, remove the filter and clean and rinse it under running water. You can remove the filter by holding between your thumb and index finder and lightly pulling from right and left sides. * Furring may occur within the interior of water heater in normal conditions of use and may result in some colorvariations. Furring accumulated in water heater can be eliminated by boiling equal amount of vinegar and water (5COml/2 glasses of each is recommended). When water boils allow the mixture remain in device for a few hours or overnight. Empty the mixture and fill the water heater up to the MAX level with fresh water. Boil and empty water. Repeat this procedure for intense furring. NOTE: This calcification intervals might be delayed by emptying remaining water every time and refilling the device. • Do not use abrasive cleaners. * Do not immerse the power cord and water heater into water Short power cord is provided to reduce winding and tripping hazards. Provided that required care is taken, an extension cord might be used. If an extension cord is used.