Sinbo Sinbo SK-7324 Kettle
FILTER PLACING 1. Open the lid by pressing on the lid release button. 2. Place the filter between the two grooves near the spout at the front Of the kettle, 3. Ensure that the filter is pressed down to the bottom of the grooves and fits correctly, then close the lid. Never leave the filter loose in the kettle. Never remove the filter While the kettle contains hot water. FILLING 1. Remove the kettle from the base unit. 2. You can fill the kettle with water via the spout or by opening the lid, by pressing on the lid release button. 3. Not recommended to fill with less than Iliter of water to prevent the kettle from running dry. 4. Never fill the kettle beyond the maximum lever indication. Avoid overfilling to prevent the water from spilling out during the boiling process. SWITCHING ON l. After filling your kettle With water, place the kettle on the base unit. 2. Connect plug to power supply and pull down the On/Off switch. The appliance will begin to operate and the indicator light will come on. SWITCHING OFF When the water has reached boiling points, the kettle will switch off automatically and the indicator light Will go Off. NOTE: This appliance has a safety system, which automatically switches off the heater element if the appliance is inadvertently switched on when empty. or if it boils dry. In this case. let the appliance cool down completely. before filling With water again. SWITCHING ON AGAIN The kettle can be switched on again after cooling down for about 15020seconds, after the kettle has been switched off automatically. CARE AND CLEANING 1. Always remove the plug from the power supply and let the appliance cool down completely. 2. Clean the outside of the kettle and the base unit with a soft damp cloth. Then wipe with a dry cloth. DO not use Scouring. 3. Descale at regular intervals. use a descaling agent, which can be obtained from specialist shops and follow the instructions given. FILTER CLEANING 1. Remove the filter out of the kettle. 2. Place under a tap and rub gently. 3. Replace the filter between the two grooves near the spout at the front of the kettle. STORAGE The cord could be winded into the base unit that has a cord storage compartment.