AFTER-SALES SERVICE
Before contacting After-Sales Service: SERVICE on the data plate on the inside of the
1. See if you can solve the problem yourself with appliance)
the help of the “Troubleshooting guide". • your full address
2. Switch the appliance on again to see if the • your telephone number and area code
problem has been solved. If it has not,
disconnect the appliance from the power supply
and wait for about an hour before switching on
again.
3. If the problem persists after this course of Note:
action, contact After-sales Service. The direction of door opening can be
changed. If this operation is performed by
Specify: After-sales Service it is not covered by the
• the nature of the problem warranty.
• the model The door cannot be reversed on models with
• the Service number (the number after the word front handle.
INSTALLATION
• Install the appliance away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near heat
sources (heaters, radiators, cookers) will increase power consumption
and should therefore be avoided.
• If this is not possible, the following minimum distances must be
respected:
- 30 cm from coal or paraffin stoves;
- 3 cm from electric and/or gas stoves.
• Fit the spacers on the rear of the condenser positioned at the back of
the appliance (see figure).
• To optimize appliance efficiency, leave a 5 cm gap above the appliance
and make sure that adjacent kitchen units are sufficiently distanced to
allow air circulation.
• Install the appliance in a dry, well-ventilated place, and ensure it is level,
using the front adjustment feet if necessary.
• Clean the interior.
• Fit the accessories.
Electrical connection
• Electrical connections must be made in accordance with local
regulations.
• Voltage and power consumption are indicated on the rating plate inside
the appliance.
• Regulations require that the appliance is earthed. The
manufacturer declines all liability for injury to persons or
animals and for damage to property resulting from failure to
observe the above procedures and reminders.
• If the plug and socket are not of the same type, have the socket
replaced by a qualified electrician.
• Do not use extension leads or adaptors.
Disconnecting the appliance
It must be possible to disconnect the appliance by unplugging it or by
means of a two-pole switch fitted upline of the socket.
Please purchase PDF Split-Merge on www.verypdf.com to 18 remove this watermark.