Rernember
Motor running time depends on different things: number of door openings, amount of food stored,
temperature of the room, setting of the temperature controls.
lf, after perforrning the above chedcs, your appliance stili does not work properly, contact the After-sales
Servise, explain the problem, specifying the model and appliance service number (stated on the data
Plate)
It thetor temperature is too high
• Es the tante installed near a heat source?
• Are the refrigerator controls correcdy set?
• Has a large amount of food been added to the refrigerator or freezer?
• Check that the doors are not opened too etten,
• Check that the doors dese properly.
• Make sure that air flow vent* Inside the compartrnent are not blocked. as this prevents the circuletion
of cold air.
if there is molsture belld-up
• Make sure that the food is properly packaged. Dıy any darnpness on food containers before placing
thern in the refrigerator.
• Check that the doors are not opened too often. When the door b opened, humidity from the room air
enters the refrigerator. The rnore aftan the door is opened, the (astar humidity builds up, especialiy
when the roorn itself la very humid.
• If the roorn is very humid, it is normal for moisture to build up inside the refrigerator.
• k is normal for droplets of water to form on the rear wan after the autornatic defrost cycle.
the doors de not open and close properly
• Check diet food paricages are not blocking the door.
• Chedc Mat the door trays. shelves and drawers are all positioned correctly.
• Check that the door seals are not dirty er sticky.
• Ensure the appliance is levet
Always disconnect the refrigerator from the power supply before replacing any bght bulbs.
if the Inside light k not working
• Disconnect the appliance from the mains power supply.
Depending on the model
• Rernove the bulb cover (depending on model)
• Unscrew or remove the bulb.
• Check the bulb and d necessary replace it.
• Some modele are equipped with rı special bulb, which does not unscrew. Pull towards the inside of the
appliance. This bulb is available oniy from °Ur After-sales Servise. %elam using maximum i SW bulb.
AFTER-SALES SERVICE
%fare contacting After-Sales Service: Specify:
I .See If you can solve the problem yourself • the nature of the problem.
(see -Troubleshooting solda / after-sales seroice"). • the model.
2. Switch the appliance on again ta ses if the problem • the Servise number (the S digft number under the
has been solved. If it has not. disconnect the word SERVICE on the data plata on the Inside of the
apprıance from the power supply and wait for about appliance).
aaa hour before switching on again. • your fuli address,
• your teiephone number and area code
3.1f the problem persists after Mis course of action. Not*:
contact Akar-seks Service.
The direction of door opening can be changed.
lf this operadon h performed by Atter-saka
Service it is not coveıred by the warranty.
Offlall 0000 000 00000
00000000 iiiiiimmum
28