3.5Sürüm Esnasında Yapılan AyarIar 3.5 Adjustment During Tillage
• Hidrolik kollarını "çeki kontrol" pozisyonuna • Switch the tractor hydraulic lever to "traction
getiriniz. control" position.
• Pullukla ilk çizi açılıp,ikinci çiziye girmeden • After first furrow opening in the field, check
önce çizi derinliğini ve genişliğini kontrol the tillage depth and furrow width in the second
ediniz.Yeterli gevşeklik için yan kol gergi furrow opening. Check again struts for just
zincirlerini bir kere daha kontrol ediniz. enough slack.
• Arka ve ön gövdelerin sürme derinlikleri farklı • Adjust the upper link by shortening or
ise orta kolu kısaltınız veya uzatımz.Eğer orta kol extending if front side and rear side have
doğru ayarlanırsa ökçe demiri çizi tabanında hafif different tillage depth. Heel leaves slight trace on
bir iz bırakır. the bottom of the furrow opening if the plough is
• Doğru sürme derinliği ayarlandığında hidrolik properly adjusted.
kumanda kolunu ayarlı pim ile güvenli konuma • If tillage depth is too high make the proper
alimz. adjustment for a right tillage depth and secure
• Eğer pulluk sürülmemiş tarafa doğru çekiyorsa the lever with adjustment pins.
eksantriği (Şekil- 1 0)' daki gibi ç eviriniz, sürülmüş • If the plough forces the tractor pulling to the
tarafa doğru çekiyorsa (Ş ekil- 1 1 ) ' deki gibi untilled side turn eccentric like (Figure-10),If the
çeviriniz.Lama eksantrikli pulluklarda, sabitleme pulling to the tilled side like (Figure-11).For the
deliklerinin yerlerini değiştirin.(Şekil-12) ploughs with lama eccentric change hole
position. (Figure- 12)
Şekil / Figure-11
Şekil / Figure- 1 O
Şekil / Figure-12