Unimep VISION LX SERİSİ 1-2-4-6-8-10 TABANCALI ,1-2-3-4-5 ÜRÜNLÜ, LCD EKRANLI, LİTRE-PARA YAZAR , DALGIÇ/ EMİŞLİ POMPALI Akaryakıt Dağıtım Pompaları

mistake.Remove nozzle and control price section of display is showing the correct value you have entered. SPECIAL NOTICES : • Please read this manual carefully and make a practice on your dispenser with your staff related with operation of it. • Do not hesitate to call us, if there is a point you do not understand. • If there is an error or problem on your dispenser, call the service. First notice the error code displayed on. • Please do not attempt to repair or add a device to your dispenser without informing service unit. • Please do not install an electric device on or near your dispenser. If you need such a device, apply to a qualified technician from your service. • Please do not attempt to add or connect any device to electric connection box of dispenser. Because the bottom section of dispenser is the most hazardous zone. Therefore, all equipments located within this section must be explosion proof. • We hope your dispenser will work for many years and satisfies your needing in the field of fuel distribution. POSSIBLE ERRORS AND CODES DISPLAYED ABOUT. ERROR CODE MEANING What you do? Power down or a fault on ac input like If the power is not really E-00 voltage drop or interrupt interrupted call service Place nozzle and finish this Power line voltage drop for a short time delivery and start a new E-01 while delivery is going on delivery. If this currently occurs call service. Your nozzle trigger is closed during estimated time or your Time out occurred in case of no delivery E-02 container is empty or a fault and motor was running in by-pass mode. on fuel piping or guiding hydraulics. Place nozzle. Try to power down CPU by shutting down related fuse in the power E-03 No response from pulser(s) panel and turn on again with a delay of 5 sec.If this problem continued, call service. Electromechanical totalizer can not be E-04 Call service. incremented. Sensing element failure in pulser unit of E-12 Call service. currently delivering nozzle No response from pulser 1,2,3,4..if which E-21,22,23.... Call service. nozzle is active now. This may occur in submersible type dispensers Preset sale is finished but fuel is still E-31,32,33.... if solenoid is kept open flowing in a small quantity. caused from a mechanical problem. Enter P-90 to unlock which P.OFF Dispenser is locked electronically you will find the procedure in this document . If your dispenser never works nor shows an error code, this may be a fatal error on main power or CPU unit may be out of order. Call service for changing CPU w ith a new one. 52