5. Put on the shaft protection chain to s ide lifting bar. so shaft would not be turn because of protection.
6. Get the machine paralel to earth before firt start-up.
7. There must not be any living creature between tractor and machine to start-up machine.
8. Turn the machine to side after machine is parallel to earth.
9. Do not over reyolution as 540 rpm as stated in operating isntructions.
10. Be careful that cutters are true settled after changing operation.
11. Use original cutters if olds are not run
12. Do not approach to machine withouft stopping the tractor.
13. Keep the machine transfer position when you do not use it.
14. Do not allow the persons to approach to machine. because the machine can throw some Stones or
hard things to people.
15. Before cutting operations. the field or area must be cleaned from Stones or hard things. These can
damage the machine.
16. Teke care when you work in path or stony roads.
17. The modifications and/or alterations made by the client will be on account and the responsibility of the
clıent, the manufacturer to be exonerated from liabiiity.
09 BAKIM TALİMATI (MAINTENANCE INSTRUCT)ONS)
1-) GÜNLÜK BAKIM
a. Makina ile kesme işlemi bittiği zaman makine üzerinde bulunan tüm gresörlüklere gres yağı basınız.
b. Kesme işlemi bittikten sonra makinenin kesme bıçaklarını. kayışlarını kontrol ediniz. Herhangi bir uygunsuzluk
tespit ederseniz hemen gerekli işlemleri yapinız.
1-)DAILY MAINTENANCE
a. Use the lubricating Grease after every cutting operation.
b. Check teh cutters and belts after cutting operations.
I 3