1__I_I_1
100827_REM_IFU_IPL5000_21L
1-1
GB14-GB15
.11.1
05.11.10 1:13:25
15
■
Do not depilate (waxing, plucking, threading or creams) during the treatment – shaving is
acceptable as long as you avoid shaving 24 hours after each treatment.
■
Do not use bleaching creams or perfumed products for 24 hours after treatment.
■
Do not scratch or pick at the treated area.
Cleaning Your i-Light Device
CAUTION: Before cleaning your i-Light device, make sure that the power switch is OFF and the
power cord is disconnected from the base unit.
■
Regular cleaning helps to ensure optimal results and a long life for the i-Light device.
The exterior surface of the base unit and hand piece may be wiped clean with a slightly
damp cloth.
■
To clean the Flash Window, use only the lint-free cloth included with your i-Light device.
Take care not to scratch or chip the Flash Window. Scratches and chips can reduce the
effectiveness of the unit.
■
For stubborn stains, use a dampened cotton swab to apply a small amount of water to
the Flash Window and clean with the lint-free cloth provided.
■
Use a small hand-held vacuum to remove dust and debris from the hand piece vents.
WARNING: If the Flash Window is cracked or broken, the unit must not be used.
Never scratch the filter glass or the metallic surface inside the Nose
Cone.
CAUTION:
The i-Light is a high voltage device. Never immerse in water. Never
clean the unit or any of its parts under the tap or in the dishwasher.
Do not use petroleum-based or flammable cleaning agents because
of the risk of fire. Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as oil or acetone to clean the unit.
i-Light Device Maintenance
CAUTION: Before performing maintenance on your i-Light device, ensure that the
power switch is OFF and the power cord is disconnected from the base
unit.
Replacing the bulb
1. Press the nose cone release buttons and gently pull to remove the nose cone.
2. Gently pull out the old bulb cartridge.
Treatment Tips
■
For best results, avoid overlapping flashes.
This helps prevent exposure to more energy
than is necessary to suppress hair growth. It also ensures that you get the maximum use
of the light cartridge.
■
For the most effective results, always use the highest intensity level that does not cause
discomfort on the skin. The level you use should feel warm on your skin, but should never
cause discomfort.
■
Optimal results are generally not obtained with a single session. For best results, repeat a
treatment session whenever you notice hair starting to regrow. Results vary by individual,
however, most people will treat areas every two weeks for the first three treatments, until
desired results are achieved.
■
You may notice that bony areas, such as elbows, shins, and ankles, are more sensitive
during treatment. This is normal and should not be cause for alarm. To avoid this
sensitivity, try stretching the skin away from the bony area during treatment.
Post-Treatment Care
After treatment, you may experience slight redness or a warm sensation on your skin.
This
is normal and will disappear quickly. To avoid irritation to your skin after a treatment, take the
following precautions:
■
Avoid sun exposure for 24 hours after a treatment. Protect the skin with SPF 30 for 2
weeks after each treatment.
■
After treatment, keep the area clean and dry and drink plenty of water to keep skin
hydrated.
■
Do not handle the treated area roughly.
■
Do not take hot baths, showers, or use steam rooms and saunas for 24 hours after
treatment.
■
Do not swim for 24 hours after treatment.
■
Do not take part in contact sports for 24 hours after treatment.
■
Do not wear tight-fitting clothing over the treated area.
■
Do not prolong sun exposure such as sunbathing, using a tanning bed, or self-tan for at
least 2 weeks after the last treatment.
14