Installing your television set
O
Insert the aerial plug
into the socket at
the rear Of the set.
Insert the mains plug
into a wall socket
(220-240V / 50 Hz).
Insert the two R6-
type batteries
(supplied) making sure
that they are the right
way round.
O
To switch on the set, press
the on/off key. If the
television remains in
standby mode. press P @
on the remote control.
Plug & PIQ
Quick installation
When you turn on the TV set for the first
time, a menu is displayed on screen. This menu
prompts you to select the country:
/fthc menu is not displayed, press and hold down
the Z- and Z+ keys on the TV set [or 5
seconds to display the menu.
O Use the keys on the remote control to
select your country and validate with O.
/fyour country does not oppeor in the list, select
choice '
Program sort
O Press key e. The Main menu is displayed on
the screen.
O With the @ key, select Manual Store and
press O.
Manual Store
'S stem
• Search
Program NO.
• Fine Tune
• Store
Furn
The search starts automatically.All the available
TV programmes will be stored. This operation
takes a few minutes. The display shows the
progress of the search and the number of
programs found. At the end Of the search, the
menu disappears. To exit or interrupt the search,
press O. f no programme is round, see Tips chapter
at the end or the instruction [or use.
If the transmitter or cable network sends the
automatic sort signal, the programs will be
numbered correctly. In this case, the
installation is complete.
If this is not the case, you need to use the
Sort menu to number the programs correctly
Some transmitters or cob/e networks broadcast
their own sort parorneters (region, jonguoge, etc.).
In this case, indicate your choice using the
keys and va/idote with
Use the or keys to select the
program you wish to renumber.
Then use the @ key to select Program NO
and enter the new number with the
keys.
With the @ key, select Store and press O.
Repeat steps O to for each program you
wish to renumber.
To quit the menus, press C.
NO
sw
ES
cz
SK