Kullanım Kılavuzları
STARTING AND STOPPING Starting and stopping WARNING! Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Otherwise the clutch can come loose and cause personal injuries. Place the machine on firm ground. Make sure you have a secure footing and that the chain cannot touch anything. Keep people and animals well away from the working area. Cold engine Starting: The chain brake must be engaged when the chain saw is started. Activate the brake by moving the front hand guard forwards. (23) Air purge: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. (26) Choke: Pull the blue choke/fast idle lever out to the full extent (to the FULL CHOKE position). When the choke/ fast idle lever is pulled out to the full extent, the correct throttle setting is set automatically. (24) Start throttle: The correct choke/start throttle setting is obtained by moving the control to the choke position. (25) Starting Grip the front handle with your left hand. Hold the chain saw on the ground by placing your right foot through the rear handle. Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly until the engine fires. Never twist the starter cord around your hand. (28) CAUTION! DO not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine. Push in the choke control to the "HALF choke" setting as soon as the engine fires which can be heard through a puff sound. (24) Keep on pulling the cord powerfully until the engine starts. As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by quickly pressing the throttle trigger once. This prevents unnecessary wear to the clutch, clutch drum and brake band. (29) 1153988-26 Rev.3 2012-03-09 Note! Reactivate the chain brake by pulling the front hand guard back (marked "PULL BACK TO RESET") towards the front handle. The chain saw is now ready for use. (30) There is a simplified start reminder with illustrations to describe each step on the rear edge of the saw. Warm engine Use the same procedure as for starting a cold engine but without setting the choke control in the choke position. Set the throttle to the start position by pulling out the blue choke control to the choke position and then pushing it in again. (27) WARNING! Long term inhalation Of the engine's exhaust fumes, chain oil mist and dust from sawdust can represent a health risk. Never start a chain saw unless the bar, chain and all covers are fitted correctly. See instructions under the heading Assembly. Without a bar and chain attached to the chain saw the clutch can come loose and cause serious injury. (31) The chain brake should be activated when starting. Se instructions under the heading Start and stop. Do not drop start. This method is very dangerous because you may lose control of the saw. (32) Never start the machine indoors. Exhaust fumes can be dangerous if inhaled. Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment. Always hold the saw with both hands. The right hand should be on the rear handle, and the left hand on the front handle. All people, whether right or eft handed, should use this grip. Use a firm grip with thumbs and fingers encircling the chain saw handles. (33) Stopping Stop the engine by pressing down the stop button. (34) English — 17