12
English
SAFETY INSTRUCTIONS
1.1 The appliance you have purchased is a technologically advanced
product designed by one of the leading European manufacturers
of high pressure pumps. To obtain the best performance from your
unit, read this booklet carefully and follow the instructions each
time you use it. We congratulate you on your choice and wish you
successful operation.
SAFETY RULES/RESIDUAL RISKS
2.1
SAFETY "MUST NOTS"
DO NOT use the appliance with
2.1.1
nfiammable or toxic liqu'ds, or
any products which are not compatible with the correct operation
of the appliance. EXPLOSION OR POISONING HAZARD
DO NOT direct the water jet towards people or
2.1.2
animals. INJURY HAZARD
DO NOT direct the water jet towards the unit
2.1.3
itself, electrical parts or towards other electrical
equipment ELECTRIC SHOCK HAZARD
2.1.4
2.1.5
DO NOT use the appliance outdoors in case Of rain. SHORT
CIRCUIT HAZARD
DO NOT allow children or incompetent persons to use the
appliance. INJURY HAZARD
DO NOT touch the plug and/or socket with wet
2.1.6
hands. ELECTRIC SHOCK HAZARD
DO NOT use the appliance if the electrical cable is
2.1.7
damaged. ELECTRIC SHOCK AND SHORT CIRCUIT HAZARD
DO NOT use the appliance if the high pressure
hose is damaged. EXPLOSION HAZARD
DO NOT jam the trigger in the operating position. ACCIDENT
2.1.9
HAZARD
Check that the data plates are affixed to the appliance, if
2.1.10
• not, inform your dealer. Units without plates must NOT
be used as they are unidentifiable and potentially dangerous.
ACCIDENT HAZARD
DO NOT tamper with or adjust the setting of the
2.1.11
safety valve or the safety devices. EXPLOSION HAZARD
2.23
2.2.4
2.2.5
2.2.7
2.2.8
2.2.9
2.2.10
2.2.11
The appliance may cause network noise DURING startup.
•Use of a safety residual current circuit-breaker (R.C.C.B.) will
provide additional protection for the operator (30 mA).
Models supplied without plug must be installed by qualfied staff.
Use only authorized electrical extension leads with suitable
conductor gauge.
Hgh pressure may cause parts to rebound: wear all the protective
clothing and equipment needed to ensure the operator's safety.
INJURY HAZARD
Before doing work on the appliance, REMOVE the plug.
ACCIDENTAL START-UP HAZARD
Before pressing the trigger, GRIP the gun firmly to
counteract the recoll. INJURY HAZARD
As
COMPLY WITH the requirements of the local water
supply company. According to EN 12729 (BA), the
appliance may only be connected to the mains drinking water
supply if a backflow preventer valve with drain facility is installed in
the supply hose. CONTAMINATION HAZARD
Maintenance and/or repair of electrical components
MUST be carried out by qualified staff. ACCIDENT HAZARD
DISCHARGE residual pressure before disconnecting the
unit hose. INJURY HAZARD
Before using the appliance, CHECK every time that the
screws are fully tightened and that there are no broken or
worn parts. ACCIDENT HAZARD
ONLY USE detergents which will
not corrode the coating materials
Of the high pressure hose/electrical cable. EXPLOSION AND ELECTRIC
SHOCK HAZARD
ENSURE that all people or animals keep a
minimum distance of 16 yd. (15m) away. INJURY
HAZARD
2.1.12
2.1.13
2.1.14
DO NOT alter the original diameter Of the spray head
nozzle. HAZARDOUS ALTERATION OF OPERATING PERFORMANCE
DO NOT leave the appliance unattended. ACCIDENT HAZARD
DO NOT move the appliance by pulling on the
ELECTRICAL CABLE. SHORT CIRCUIT HAZARD
2.1.15 Make sure that cars do not drive over the high pressure hose.
2.1.16 DO NOT move the appliance by pulling on the high pressure hose.
EXPLOSION HAZARD
2.1.17 When directed towards tyres, tyre valves or other pressurised
2.2
2.2.1
components, the high pressure jet is potentially dangerous. Do not
use the rotating nozzle kit, and always keep the jet at a distance of
at least 30 cm during clean •ng. EXPLOSION HAZARD
SAFETY"MUSTS"
All electrical conductors MUST BE PROTECTED against the
water jet. SHORT CIRCUIT HAZARD
The appliance MUST ONLY BE CONNECTED to an
2.2.2
adequate power supply in compliance with all
applicable regulations (IEC 60364-1). ELECTRIC SHOCK HAZARD