0.8. Name(s) and address(es) of assembly plant(s):
KUBOTA SAKAI PLANT
64, Ishizu-Kita
Sakai-ku, Sakai-city
Osaka
Japan
I the undersigned hereby certify that the manufacturer’s description in the attached information
document of the vehicle(s) described above (a sample of each vehicle having been selected by the
EC type-approval authority and submitted by the manufacturer as prototype of the vehicle type) is
accurate and that the attached test results are applicable to the vehicle type.
1. For complete and completed vehicles/variants (1)
The type of vehicle meets/does not meet (1) the requirements of all of the relevant separate
directives.
2. For incomplete vehicles (1)
The type of vehicle meets/does not meet (1) the requirements of all of the relevant separate
directives listed in the table on page 3.
3. EC type-approval is granted/refused/withdrawn. (1)
4. EC type-approval is granted under Article 11 of Directive 2003/37/EC and shall be valid until
dd/mm/yyyy.
PLACE: BRISTOL
DATE: 21 MAY 2009
SIGNATURE: A.W. STENNING
Head of Technical and Quality Group
Annexes:
- Information file (including Parts II and III (where appropriate) of the information document model B).
- Test results
- Name(s) and specimen(s) of the signature of the person(s) authorised to sign the certificates of
conformity, and a statement as to his/their function within the organisation.
NB: If this model is used for EC type-approval pursuant to Articles 9 to 11 of Directive 2003/37/EC, it
may not bear the heading
‘Vehicle EC type-approval certificate’ except in the case referred to in Article 11 where the
Commission has approved the report.
(1) Delete whichever does not apply.
(2) If this component is not known during reception, it must be completed during the last stage
prior to the vehicle being placed on the market.
(3) As defined in Annex II, Chapter A, of Directive 2003/37/EC.
21-May-09
EBK205071 An executive agency of the Department for Transport 2