2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Illustrations on fold-out page!
EN-4
Coupling element for water
connection
Water connection with integrated sieve
Appliance switch "O/OFF"/ „I/ON"
High pressure hose
Dosage regulator for detergent
Storage for trigger gun
High-pressure hose drum
Transport handle
Hand crank for hose drum
Storage of detergent reservoir with deter-
gent connection
Storage for accessories
Storage hook for mains connection cable
Mains cable with mains plug
Detergent reservoir with locking lid
Wheels
Trigger gun
Lock trigger gun
Key to detach the high-pressure hose
from the trigger gun
Spray lance with pressure regulation
(Vario Power)
Spray lance with Dirtblaster
Washing brush
Rotary washing brush
Delta-Racer DI 50
Special accessories
Special accessories expand the possibilities
of using your appliance. Please contact your
KÄRCHER dealer for further information.
Before Startup
3
Mount loose parts delivered with appliance
prior to start-up.
Install wheels
Illustration
Push the wheels into the intake and se-
cure them with the plugs. Align the plug
properly.
Install the storage for hand-spray gun
Illustration
Place the bottom holder into the recesses
and push forward until it audibly Icoks in.
Insert the top holder and push down all
the way.
Install the storage hook for the mains
connection cable
Illustration
Press in the storage hook and lock it into
the top position.
Install the transport handle
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Slide the transport handle into the guide
and secure it with 2 screws.
Install the dosage regulator for deter-
gent
You will need the 2 included screws as well as
a Philips screwdriver PH 2.
Illustration
Insert both detergent hoses onto the hose
fittings.
Install the dosage regulator and connect
using 2 screws.
Note: During installation you must make
sure that the tongues of the dosage regu-
lator match up with the intended recesses
in the casing.
Install the high pressure hose drum
Illustration
Slide the free end of the coiled high pres-
sure hose through the recesses on the
dosage regulator.
Insert the hose drum into the intakes on
the transport handle.
Insert the axle of the hand crank into the
guides.
Install the fixating plate and secure it us-
ing 2 screws.
Press the connecting fitting from the short
high pressure hose into the brass intake,
secure with clamps.
Note: Make sure the connection nipple is
aligned correctly.
Connect the high pressure hose to the
hand spray gun
Illustration
Push the high pressure hose into the trig-
ger gun until it locks audibly.
Note: Make sure the connection nipple is
aligned correctly.
Check the secure connection by pulling
on the high-pressure hose.
13